Electrical Diagram; List Of Components - Zummo Z1 Manual Del Usuario

Breakage of guide plate
Not enough juice is being
extracted from the fruit
The second half of the
orange turns around
The orange rebounds in
the cup and misses the
blade
Oranges pop out from the
paddle
For any advice or to request spare parts, you should state the model and serial number of your machine (Fig.
5).
15

ELECTRICAL DIAGRAM

1 Fuse
2 Power switch
3 Circuit board
4 Superior protection sensor
5 Front-cover micro-switch
6 Front-cover micro-switch
16

LIST OF COMPONENTS

0502007A COVER CLASP
0503001 FEEDER PADDLE
0504013 PRESS PLATE FASTENER
0504014-1 CUP SLIDE
0504020 PLASTIC WASHER 7,5/15 X 1,5
0505016 PEEL EXTRACTING BANDS
0506005/1 FRONT COVER MICRO HOOP
0506006/1 SQUEEZING TRAY-MICRO CLAMP
0506007 MICRO (SHORT)
0506008 MICRO (LONG)
0506010 ELECTRIC LEAD
The Peel Extracting Bands are loose or broken and peel is piling up in the
Juicer tray.
The nut of the cup is not tight enough.
The ball in the squeezer tray is loose.
The skin of the fruit is too thin. Check that the washer is fitted underneath
the ball; fit a maximum of one washer.
Orange may be too small for the cup and ball set being used. Fit the
medium set, or the cup with the elastic accessory.
Check the size of the oranges in the calibrator.
Orange may be too large for the cup and ball set being used. Fit the large
set with the elastic accessory.
Check the size of the oranges in the calibrator.
The paddle shaft is too dry; proceed to grease it. (Fig. 15)
7 Tray micro-switch
8 Motor
9 Bin sensor
10 Counter micro-switch
11 Condenser
12 Photocell
0506014 POWER BASE
0506015 BLACK BIPOLAR SWITCH
0506021 CONNECTION
0506027 BLANKING PLUG Ø17,3
0508013 MACHINE FOOT 85MM
1003031 SQUEEZER FRONT COVER NUT
1901001 CASING UNIT
1901002 CASING CLOSURE
1901003 SQUEEZING-TRAY SHAFT
1902001 FRONT
1902002 BODY
19