Scott MOTO SPORTS Manual Del Usuario página 7

350 EVO, 350 PRO, 350 KIDS HELMETS
Remove the two side screws and washers from the visor. Remove the central screw
located underneath the visor. To replace the visor, reverse the mentioned process.
Avoid damage to the visor by over tightening the screws. Use the central screw to lock
the visor in your favored position. If in doubt about maintenance or how to remove
or replace parts of your helmet, please see your local dealer. DO NOT MAKE ANY
CHANGES OR MODIFICATIONS TO YOUR HELMET OTHER THAN THOSE SPECI-
FIED BY THE MANUFACTURER, AS THIS COULD SERIOUSLY REDUCE THE PER-
FORMANCE AND SAFETY OF YOUR HELMET. SCOTT Sports SA shall not be liable
for any damages and losses due to any improper changes or modifications.
GOGGLE CARE AND FIT
It is absolutely essential that the goggles worn with all off-road helmets are always
clean and the lens is replaced regularly. See the manufacturer's instructions supplied
with your chosen goggle type. Before purchasing your goggles, ensure the goggles fit
your helmet correctly and that they do not interfere with your vision and allow the max-
imum peripheral vision. We recommend SCOTT Goggles for all SCOTT Helmets. SCOTT
Sports SA shall not be liable for any damages and losses due to not complying goggles.
REMOVING INNER LINER AND CHEEK PADS
To remove the cheek pads, gently pull the padding off from the three snap buttons
holding it in place and pull out the retaining flap from underneath the lower helmet
beading. Repeat on the other side. To remove the liner, unsnap the rear portion of the
inner located towards the rear of the helmet. Gently pull out the liner without forcing
the liner out from its front clips located at the top portion of the visor opening. Reverse
the steps to reinstall liner.
• V. CLEANING YOUR HELMET
Do not use any solvents, hot water, glass cleaners, or gasoline to clean your helmet.
These materials can cause severe damage to the helmet and weaken its structur-
al integrity. Any such damage to the helmet can prevent the helmet from perform-
ing properly in the event of an accident which could result in serious injury or death.
To clean your helmet, it is best to use lukewarm water with a damp soft cloth. Rinse
off and dry using a soft cloth. Clean your visor with warm water and rinse well. Do not
use any cleaners or solvents to clean your visor as they may damage the coating of the
visor. SCOTT helmets come with a removable liner to make the cleaning and upkeep
of your helmet interior easy and hassle free. Remove the liner and cheek pads and
hand wash with normal detergent in cold water. Let them air dry. Do not use a wash-
ing machine or tumble dry. Hand wash and air dry only. For more cheek pad and lin-
er sizing, to maximize comfort, please check with your local dealer for liner/cheek pad
sizing options. SCOTT Sports SA shall not be liable for any damages and losses due to
improper cleaning.
7 - ENGLISH