Tabla de contenido
ENGLISH
INSTALLATION INSTRUCTIONS
SHOWER PANEL with time delay valve P50
PRECAUTIONS FOR USE (The product guarantee depends on the respect for these rules)
0) INSTALLATION and COMMISSIONING
For products delivered with filters, these must be installed in accordance with the instructions.
Before commissioning any of our valves, it is essential to carefully bleed the pipes that can damage the
mechanisms or water passages (PRESTO® heads that can be dismantled from front).
Recommended operating pressure according to NF EN 816: 1 to 5 bars.
CLEANING
The chrome-plated coating of PRESTO® valves must be cleaned only with soapy water.
Abrasive, acid, alkaline or ammonia-based household products are prohibited.
MAINTENANCE
Never lubricate the internal mechanism, particularly the caps and valve seals.
1) Fixed shower heads with swivel jets
2) Fixed shower heads with swivel jets with légionellose option
3) Hand shower
4) High
5) Built-in
6) Feed
7) Grey finish RAL 7035
8) Creamy white finish RAL 9001
9) Button + 3 screws
10) Filter Seal ½
11) Straight Shut-off Valve G1/2
12) Angle Shut-off Valve G1/2
13) Pin
14) Screw VBA TC 4x40 + washers
15) Preparation
16) INSTALLATION
17) Bleed the pipes
18) Hand shower Version
19) Removal of the soap holder bottom part
20) Removal without soap holder for bottom part maintenance.
21) 2.1m from the floor to the shower head precaution see covers page 6
22) Re-assembly while retaining the soap holder
23) Use without soap holder. Installation of the button
24) Installation of the soap holder
25) Equipotential bonding: Connect the connecting wire to an open lug D4 (not provided) to be inserted below
this screw.
26) Hydraulic Connection
27) Top inlet
28) Built-in inlet
29) Maintenance
Replacing the Time delay Cartridge:
Head part number see PRESTO catalogue
• Turn off the water inlet
• Remove the panel (see pages 3 and 4)
30) Removing valve P50
31) Removing the head
32) Reassembly in reverse order
33) Replacing the Shower Grille Part number: 90185 (grille only) Part number: 90184 (grille + screw + limiter)
• Unscrewing expansion screw
• Replacement
34) Ceiling
35) Installation precaution for subsequent cover option
36) Position dimensions for placing covers optionally delivered
37) Floor
38) Recommended installation dimension 968 mm to 972 mm
This document is not contractual, we reserve the right to modify the characteristics of our products without
notice.
PATENTED and REGISTERED MODELS
Tabla de contenido
