Unpacking; Assembly - Ryobi RY803111 Manual Del Operador

UNPACKING

This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Pressure Washer
Handle
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-Connect Nozzles (4)
4-Cycle Engine Lubricant (SAE 30 or SAE 10W30)
RYOBI 18V ONE+ Battery Pack
™
™
RYOBI 18V ONE+ Charger
™
™
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product with
damaged or missing parts could result in serious personal
injury.
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
All manuals and user guides at all-guides.com

ASSEMBLY

To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
INSTALLING THE HANDLE
See Figure 2.
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
 Push and hold the button on the handle as you slide the
CONNECTING THE BATTERY CABLE
See Figures 3 - 4.
The battery cable must be connected and a RYOBI
ONE+
start feature.
 Locate and unwrap the battery cable.
 Plug the battery cable into the input jack on the back of
 Secure the battery cable in place using the clips on the
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 5.
 Place the threaded end of the spray wand in the connector
 Turn the connector until it stops to secure the spray wand
CONNECTING THE HIGH PRESSURE HOSE
TO THE TRIGGER HANDLE
See Figure 6.
 Screw the collar on the high pressure hose into the trigger
 Pull on the hose to be certain it is properly secured.
Page 8 — English
WARNING:
CAUTION:
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock button
snaps through the locking slot to secure the handle in
place.
battery pack must be installed to use the electric
™
the front panel.
handle.
on the end of the trigger handle.
in place.
handle inlet coupler by turning the hose collar clockwise.
Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.
18 Volt
™