EdmoLift AL Manual De Productos página 183

EdmoLift Products Manual
Installation of Lift tables, Arm lifts, Pallet lifts, and Tilts
At all times during work under the platform the service supports (maintenance chocks) must be in place. Any
applicable Building, Construction and Safe Use Regulations must be complied with. A qualified electrician must carry
out the electric installation, and competent technicians must undertake the mechanical installation.
An isolator switch needs to be installed and during operation it must be accessible to the operator. Check that the lift´s
voltage conforms with the electrical supply and that the feed cables and fuses are suitable for the power requirements.
The control unit must contain an Emergency Stop device, and further Emergency Stop devices may be required
to provide safe operation in the area of work.If the control unit is placed on the platform there must be at least one
additional Emergency Stop adjacent to the lift.
If an extra control unit is fitted it is required to be wired in series with the first control unit. A 5-wire cable is required for
such connection.
NOTE! The table must be unladen during installation work.
Unpacking
Check that there is no transport damage. Electrical cable (´test tail´)
for provisional connection is located within the power pack.
Do not lift on the safety frame.
Damage and operational problems can result. (The lift can be raised
but not lowered.)
Connect the mains power feed cable plug. The mains power feed cable has 4
wires, 3 phases (black, blue, brown) and earth (green-yellow).
A neutral wire is not usually used. CEE – plug, motor-protection and mains
isolator are not normally included on delivery.
Switch on the mains.
If the motor runs and the table does not raise? Change round two phases. It is
important that the motor is not run for too long in the wrong direction as this can
cause damage to the pump.
Copyright © EdmoLift AB 2004-2007
All rights reserved. No part of this publication may be reproduced, stored in a retrie-
val system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise without the permission of the publisher.
2005-02-01
EdmoLift AB
Jägaregatan 11
S-871 42 HÄRNÖSAND, SWEDEN
85921 GB
Tfn. +46 (0)611-83 780
37
Fax. +46 (0)611-51 15 80
[email protected]