EdmoLift AL Manual De Productos página 172

EdmoLift Products Manual
Technical data for standard WP Work Positioner model
Note! Maximum load refers to the load being uniformly distributed over the entire platform area.
.
Note that max. load refers to load that is equally divided over the whole platform on the basic performance of each
work positioner model. Actual capacity with accessories is detailed for each accessory according to the table on the
next page. If the accessory is added by the purchaser a new weight decal might be required on the work positioner.
According to the work positioner standard EN 1757-1 the basic requirements are:
* 100% of the rated load distributed over the entire platform/attachment area.
* The load centre must be in the centre of the platform/attachment
* Horizontal forces are not permitted.
Horizontal forces can occur, for example, when pressing on to the lift or the load, or when pulling or pushing a tool or
component on the platform or the pallet. If the horizontal force is applied on the load tilting moment increases.
It is difficult to estimate the size of the actual horizontal force, so utmost care must always be taken.
For any other type of loading, see load distribution decal on the work positioner.
G = Centre of Gravity
H = Max. platform height
Q = Max. permitted load (capacity)
D = Max. centre of gravity. Distance from the mast in relation to the platform/attachment area.
D may not exceed half the platform length.
Please contact EdmoLift to discuss specific load if it does not meet standard criteria
Copyright © EdmoLift AB 2004-2007
All rights reserved. No part of this publication may be reproduced, stored in a retrie-
26
val system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise without the permission of the publisher.
2005-02-01
EdmoLift AB
Jägaregatan 11
S-871 42 HÄRNÖSAND, SWEDEN
85921 GB
Tfn. +46 (0)611-83 780
Fax. +46 (0)611-51 15 80
[email protected]