General Safety; Operational Safety - Herschel Vulcan Serie Instrucciones De Instalación Y Funcionamiento

• This appliance must be disconnected from its power source during installation or service activities and
when replacing.
• Mains electrical supply must provide disconnection from the heater from all poles and must be
incorporated into the fixed wiring according to wiring regulations.

GENERAL SAFETY

All heaters leave Herschel fully tested and verified as being fit for operational use. To avoid any
•
possible issues caused by transportation, check the packaging for visible damage or tampering.
Remove the packaging and inspect the heater for any sign of damage. If you are in any doubt, do not
use the unit and contact your supplier.
• Familiarise yourself with the installation and operation of this heater.
Only use lamps from Herschel.
•
• Only use mounting kits from Herschel in order to maintain correct clearances from walls and ceilings.
DO NOT
mount the heater directly to a ceiling surface: always use the Ceiling Chain Installation kit.

OPERATIONAL SAFETY

WARNING! DO NOT
•
WARNING! DO NOT
•
WARNING! DO NOT
•
qualified personnel only.
WARNING! DO NOT
•
temperatures in use. After the heater has been switched off the elements remain hot for a
considerable time and the unit should not be touched within 30 minutes minimum. Please attach the
supplied notice
a location where it can easily be seen.
WARNING!
•
the lamps will develop hot spots and become damaged.
• WARNING!
This heater is not equipped with a device to control the room temperature. Do not use
this heater in small rooms when they are occupied by persons not capable of leaving the room on their
own, unless constant supervision is provided.
WARNING!
Ensure you observe the safety distances (see Table 2) and there is no possibility of
•
contact with flammable materials during operation.
WARNING!
•
allow other materials to blow onto the heater. If a heater should become accidentally covered during
operation, turn it off immediately and remove any foreign objects that have covered the heater or
become lodged in the grill.
WARNING! DO NOT
•
These must be replaced by Herschel, its service agent or similarly qualified persons in order to avoid a
hazard.
WARNING! DO NOT
•
use in areas where hazardous vapours or very fine powders are present.
move the heater whilst in operation or even when still warm.
disassemble the heater for any reason. This heater must be checked by
touch the heater when in use. The Herschel Vulcan rises to very high
CAUTION DO NOT TOUCH HEATER
Never touch the lamps directly with your fingers. Clean with a soft clean cloth otherwise
In order to avoid overheating and potential fire hazard,
use the heater if the bulbs, ceramic bulb holders or power cord are damaged.
use the heater to ignite materials.
to the wall or ceiling near the heater or in
DO NOT
ENGLISH
cover the heater or