MTD 020 Serie Manual De Instrucciones página 12

Control Cable
NOTE: Your mower has been supplied with one of two types of
control cables - one that is secured with a snap fitting as shown
in Figure 3-14 or one that is secured with a stud as shown in
Figure 3-15. Make note of the cable supplied with your mower
and follow the appropriate steps.
Control Cable (Snap Fitting)
Unwrap the control cable from the engine and route it under the
lower handle.
Z Fitting
1. To make it easier to attach the Z fitting, temporarily remove
the left side of the blade control as shown in Figure 3-12.
Blade Control
Upper
Handle
2. Hook the Z end of the control cable into the control from
the inside to outside. See Figure 3-12.
3. Reattach the left side of the blade control.
Securing Control Cable
NOTE: Use cable tie shown in Figure 3-13 from the hardware pack
to secure the control cable.
WARNING:
avoid contact with all sharp edges and hot surfaces.
Such contacts damage the cable and render the
controls inoperative.
1. Press the stud found inside the snap fitting into the hole
found on the left side of the upper handle, as shown in
Figure 3-14.
12
S 3 — A
ection SSembly
Z-Fitting
Figure 3-12
Qty. 1
Figure 3-13
The cable must be routed properly to
& S -U
et p
Snap
Fitting
Figure 3-14
2. Secure the cable to the lower left handle with the cable tie.
Trim off the extra length of the cable tie.
STOP!
Continue to Starter Rope (page 13).
STOP
Control Cable (Stud)
Unwrap the control cable from the engine and route it under the
lower handle.
Securing Control Cable
WARNING:
The cable must be routed properly to
avoid contact with all sharp edges and hot surfaces.
Such contacts damage the cable and render the
controls inoperative.
1. Press the stud found on the cable fitting into the hole
found on the left side of the upper handle, as shown in the
Figure 3-15 insets.
Stud
Figure 3-15
Stud inside
Snap Fitting
Upper
Handle
Upper
Handle
Lower
Handle