MTD 020 Serie Manual De Instrucciones página 11

NOTE: The cupped side of each washer should be pressed
against the deck. See Figure 3-8.
Wheel
Shoulder
Screw
(Cupped side facing deck)
Figure 3-8
Upper Handle
NOTE: Use hardware shown in Figure 3-9 from the hardware pack
to attach the upper handle.
Qty. 2
Figure 3-9
1. Place the upper handle in position over the lower handle
keeping the blade control (if attached) facing up as shown
in Figure 3-11 inset.
2. Secure the upper handle to the lower handle using the
1.50" carriage bolts and flange lock nuts (1/2-in. socket
wrench). See Figure 3-10.
Carriage
Bolt
Figure 3-10
Deck
Flange
Lock Nut
Washer
Qty. 2
Flange
Lock Nut
Blade Control
NOTE: If the blade control is secured and in place on the upper
handle, you may skip the following three steps. If, however, the
blade control became displaced either during shipping or during
assembly, reattach it as follows:
1. Insert the curved end of the blade control into the center
hole located on the right side of the upper handle.
See Figure 3-11.
Straight
Curved
End
1
Figure 3-11
2. Gently squeeze the blade control inward and insert the
straight end into the lower hole located on the left side of
the upper handle. See Figure 3-11.
3. Check to confirm that the blade control pivots freely
against the upper handle.
S
ection
End
2
3 — A & S -U
SSembly et p
11