Uline H-7149 Manual De Instrucciones página 6

50 SLOT SORTER WITH RISER ASSEMBLY CONTINUED
4. Place each of the inside end panels inside the
outside end panels, loop side up. The offset lip fits
under the flange on the outer edge of the outside
end panel. (See Figure 13)
NOTE: The flange on the inside end panel with
the two holes should be facing down.
5. Take the six pieces of double-faced tape and peel
off the backing on one side of tape; then apply two
to the bottom of each outside end panel and two to
the back panel. (See Figure 13)
Figure 13
6. With the assistance of another person, each lifting from
an end panel, swing the end panels up 90 degrees from
the back panels, and set the unit upright. (See Figure 14)
Figure 14
7. To install shelves, begin with the bottom shelf (1" front
flange and no divider slots). Position the shelf so
its tabs (on side flanges only) lock into the bottom
rows of loops on the inside end panels, and its back
flange is held by the tabs on the back panel, and
set it gently into place. Repeat this same procedure
with the four shelves with slots in them. (See Figure 15)
PAGE 6 OF 21
Figure 15
8. To install dividers, insert a divider through each slot.
Dividers slide down through slots in all shelves until
they rest on the bottom shelf. (See Figure 16)
NOTE: The end of each divider with the two
holes should be facing up.
Figure 16
Tape
9. When all the
dividers are in
place, pull each
one forward to
lock into position.
Insert the plastic
buttons into the
holes behind the
dividers on the
top and bottom
shelves with
divider slots.
(See Figure 17)
Figure 17
0621 IH-7149