Uline H-7149 Manual De Instrucciones página 3

Left Hand
Outside End
Panel
Shelf (1" Flange) x 3
1. Unpack carton and identify all parts. Peel off
protective film from face side of all flat steel parts.
2. Position the two outside end panels (flange side up)
and the two back panels (tab side up) as shown on
a smooth, non-marring surface. Bottom back panel
has wire cutouts on bottom. (See Figure 6)
3. Lift up one side of the bottom back panel and insert
tabs through the lower slots in the adjacent end
panel. Repeat with other side. Then do the same
with top back panel. The lower edge of the top
back panel will slightly overlap the upper edge of
the lower back panel. (See Figure 6)
Figure 6
Back Panel
PAGE 3 OF 21
50 SLOT SORTER PARTS
Bottom Back
Panel
50 SLOT SORTER ASSEMBLY
Outside End Panel
Right Hand
Inside End
Panel
Left Hand
Inside End
Panel
Top Back
Panel
4. Place each of the inside end panels inside the
outside end panels, loop side up. The offset lip fits
under the flange on the outer edge of the outside
end panel. (See Figure 7)
NOTE: The flange on the inside end panel with
the two holes should be facing down.
Figure 7
Inside End Panel
5. Take the six pieces of double-faced tape and peel
off the backing on one side of the tape; then apply
two to the bottom of each outside end panel and
two to the back panel. (See Figure 7)
Right Hand
Outside End
Panel
Divider x 8
Shelf (1/2" Flange) x 8
Double-faced Plastic Buttons
Tape x 6 x 12
Tape
0621 IH-7149