Uline H-7149 Manual De Instrucciones página 2

5. Using a hammer
or rubber mallet,
pound the glide
insert into the leg,
and screw the leg
glide into the glide
insert. (See Figure 2)
6. Place legs into the leg sleeves at the corners of the
table. (See Figure 3)
NOTE: Each leg has two threaded holes at the
upper end; legs should be inserted so that the
holes line up with the adjustment holes in the
leg socket.
NOTE: Table height can be adjusted between
29" and 36" in one inch increments.
(See Figure 4)
7. Using two screws fasten the leg in place (Allen
wrench provided). (See Figure 3)
Figure 3
8. Once all four legs have been assembled in place,
carefully set table upright. Adjust leveling glides as
needed to level out table.
PAGE 2 OF 21
ASSEMBLY CONTINUED
Figure 2
Leg Glide
(Leveler)
Glide Insert
Leg
Figure 4
Table Height Max. 36"
Table Height
Adjustment
Range 29" to 36" in
One Inch Increments
Table Height Min. 29"
Go to page 3 for 50 Slot Sorter Assembly Instructions or
page 5 for 50 Slot Sorter with Riser Assembly Instructions.
SHELF INSTALLATION
1. Carefully put the two half-shelves in place, first one,
then the other. They should now be next to each
other, resting on the flanges at the bottom of the
back and side panels.
NOTE: Side with notched corners should be
placed towards outside of table.
2. Insert four painted screws. Each one will go through
the hole at the bottom of the table leg frame and
the front corner of one of the half-shelves. Secure
them with the keps nuts provided. (See Figure 5)
3. Connect the two half-shelves from underneath
through the bottom flanges using three painted
screws and three keps nuts. (See Figure 5)
Figure 5
0621 IH-7149