Uline H-7149 Manual De Instrucciones página 4

6. With the assistance of another person, each lifting
from an end panel, swing the end panels up 90
degrees from the back panels and set the unit
upright. (See Figure 8)
Figure 8
7. To install shelves, begin with the bottom shelf (1" front
flange and no divider slots). Position the shelf so
its tabs (on side flanges only) lock into the bottom
rows of loops on the inside end panels and its back
flange is held by the tabs on the back panel, and
set it gently into place. Repeat this same procedure
with the four shelves with slots in them. (See Figure 9)
Figure 9
8. To install dividers, insert a divider through each slot.
Dividers slide down through slots in all shelves until
they rest on the bottom shelf. (See Figure 10)
NOTE: The end of each divider with the two
holes should be facing up.
PAGE 4 OF 21
50 SLOT SORTER ASSEMBLY CONTINUED
Figure 10
9. When all the
dividers are in
place, pull each
one forward to
lock into position.
Insert the plastic
buttons into the
holes behind the
dividers on the
top and bottom
shelves with
divider slots.
(See Figure 11)
10. Repeat steps
seven through nine to create the second tier of
pockets in the sorter. Start by installing the top shelf
of the first tier, which has no divider slots and a 1"
front flange; this also acts as the bottom shelf for the
second tier.
11. Position the top shelf (1" front flange and no divider
slots) over the top row of tabs on the back panel
and with its tabs through the loops on the inside end
panel, and set it carefully in place.
12. Remove backing from double-faced tape previously
attached to bottom of sorter. Lower sorter onto
table and set in place. Tape will prevent sorter from
moving on table. (See Figure 11a)
Figure 11a
Figure 11
0621 IH-7149