Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
• For security you must program your own
combination after opening the safe.
• Record this new combination on this form
or store your combination on our secure
website at www.stack-on.com under
Customer Service. If you write down your
combination you must keep this information
in a secure place, away from children, not
inside the safe.
Inside safe
NOTE: Reset button is only accessible
when the locking mechanism is in the
un-locked position.
1.
Use the key to open the safe. The reset button
is only accessible when the locking mechanism
is in the un-locked position.
2.
Press the Reset Button (3) located inside the
safe. Two "beeps" will sound (if the sound is
turned on) and all 3 buttons will flash blue twice.
You will have 5 seconds to begin entering your
combination or you will have to start over.
3.
Enter your own 3-8 button combination by
pressing any combination of the 3 buttons.
Example: (RIGHT) - (LEFT) - (CENTER) -
(LEFT) - (RIGHT)
4.
For Each combination entry a "beep" will sound
(if the sound is turned on) and all the buttons will
light up green. If you delay more than 5 seconds
between entries there will be 2 beeps (if the
sound is turned on) and 2 red flashes and you
will have to start over from step 2. After you
have finished entering your combination, you will
have 5 seconds to press the Reset Button to
record your new combination or you will have to
start over from step 2.
When you press the Reset Button to record your
new combination, there will be two "beeps" (if the
sound is turned on) and all 3 buttons flash blue
twice, indicating your new combination has been
recorded.
3
Reset Button
5.
To confirm your combination was entered correctly,
turn the key to the locked position (the door may
remain open) and follow the instructions in the
"OPENING THE SAFE USING YOUR
COMBINATION" section.
If the combination you entered does not activate
the locking mechanism, you will need to go back to
step 1 in this section.
CLOSING THE SAFE
Lift up the up the holster compartment until
the L shaped brackets clear the inside of
the frame. Rotate the L bracket back so
they point to the top of the safe and then
push them out towards the safe body which
will hold the holster compartment up. Then
rotate the L brackets back into the guides
on the back of the holster compartment.
Close the compartment and hold it closed
until the green light goes on and the unit
beeps.
NOTE: When closing the safe with a pistol
in the holster compartment, make sure the
pistol does not interfere with the frame of the
safe.
NOTE: To verify your combination the
locking mechanism must be in the
locked position.
3
16
40543-1511
Tabla de contenido
