Troubleshooting - Weber Q 300 Guia Del Propietario

PROBLEM
Burners burn with a yellow or orange
fl ame, in conjunction with the smell of gas.
Symptoms:
Burners do not light. -or- Burners have a
small fl ickering fl ame in the HIGH position.
-or-
Barbecue temperature only reaches 250˚F
(121˚C) to 300˚ F (148˚C) in the HIGH
position.
Burner does not light, or fl ame is low in
HIGH position.
Experiencing fl are-ups:
CAUTION: Do not line the bottom tray
with aluminum foil.
Burner fl ame pattern is erratic. Flame is
low when burner is on HIGH. Flames do not
run the whole length of the burner tube.
Inside of lid appears to be "peeling."
(Resembles paint peeling.)
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the
contact information on our web site. Log onto www.weber.com

Troubleshooting

CHECK
Inspect Spider / Insect Screens for possible
obstructions. (Blockage of holes.)
The excess fl ow safety device, which is part of
the barbecue to cylinder connection, may have
activated.
Is LP fuel low or empty?
Is fuel hose bent or kinked?
Does the outside burner light with a match?
Are you preheating barbecue in the prescribed
manner?
Are the cooking grates heavily coated with
burned-on grease?
Is the bottom tray "dirty" and not allowing
grease to fl ow into catch pan?
Are burners clean?
The lid is Cast Aluminum, not paint. It cannot
"peel". What you are seeing is baked on
grease that has turned to carbon and is fl aking
off.
THIS IS NOT A DEFECT.
® .
CURE
Clean Spider / Insect Screens. (See Section
"Annual Maintenance")
To reset the excess fl ow safety device turn all
burner control knobs and the cylinder valve OFF.
Disconnect the regulator from the cylinder. Turn
burner control knobs to HIGH. Wait at least 1
minute. Turn burner control knobs OFF. Reconnect
the regulator to the cylinder. Turn cylinder valve on
slowly. Refer to "Lighting Instructions".
Refi ll LP cylinder.
Straighten fuel hose.
If you can light the outside burner with a match,
then check the ignition system.
All burners on high for 10 to 15 minutes for
preheating.
Clean thoroughly. (See Section "Cleaning")
Clean bottom tray
Clean burners. (See Section "Maintenance".)
Clean thoroughly. (See Section "Cleaning".)
21