Weber Q 300 Guia Del Propietario página 19

LIGHTING
Summary lighting instructions are posted on the cart leg under the control
knobs (L).
Failure to open the lid while igniting the barbecue's
burners, or not waiting 5 minutes to allow the gas to
clear if the barbecue does not light, may result in an
explosive fl ame-up which can cause serious bodily
injury or death.
1).
5).
3).
A. - OFF
C. - MED
1) Open the lid.
2) Make sure all burner control knobs are turned OFF. (Push control knob
in and turn clockwise to ensure that it is in the OFF position.)
WARNING: The burner control knobs must be in the
OFF position before turning on the liquid propane
cylinder tank valve. If they are not in the OFF position,
when you turn on the LP cylinder valve, the "excess
gas fl ow control" feature will activate, limiting the fl ow
of gas from the LP cylinder. If this should occur, turn
OFF the LP cylinder valve and burner control knobs.
Then start over.
When the "excess gas fl ow control" feature is
activated, a small amount of gas is still fl owing to the
burners. After turning OFF the cylinder valve, wait at
least 5 minutes for the gas to clear before attempting
to light the barbecue. Failure to do so may result in an
explosive fl ame-up, which can cause serious bodily
injury or death.
Operating Instructions
DANGER
6).
2).
L).
B. - START/ HI
D. - LOW
DANGER:
WARNING: Check hose before each use of barbecue
for nicks, cracking, abrasions or cuts. If the hose
is found to be damaged in any way, do not use the
barbecue. Replace using only Weber
replacement hose. Contact the Customer Service
Representative in your area using the contact
information on our web site. Log onto www.weber.com
Ignition System
Note - The ignition system ignites the burners with a spark from the igniter
electrode inside the ignition chamber. You generate the energy for the spark
by pushing the ignition button until it clicks.
4).
A
3) Turn the gas on by slowly turning the cylinder valve counterclockwise.
Wait 60 seconds.
WARNING: Do not lean over the open barbecue when
lighting the barbecue.
4) Select the Outside burner, push control knob in and turn to START/HI.
5) Push the ignition button, so that it clicks. Repeat if necessary
6) Check that the burner is lit by looking down through the cooking grate.
You should see a fl ame.
WARNING: If the burner does not light, turn the burner
control knob to OFF and wait 5 minutes to let the gas
clear before you try again or try to light with a match.
7) After the Outside burner is lit you can turn on the Inside burner. The
Inside burner is ignited from the Outside burner.
TO EXTINGUISH
Push in and turn each burner control knob clockwise to the OFF position.
Turn gas supply OFF at the source.
19
®
authorized
B C
.
®
D