LG RV1329C1T El Manual Del Propietario página 7

Exhaust/Ducting:
• Gas dryers MUST be exhausted to the outside. Failure to follow
these instructions can result in fire or death.
• The dryer exhaust system must be exhausted to the outside of the
dwelling. If the dryer is not exhausted outdoors, some fine lint and
large amounts of moisture will be expelled into the laundry area.
An accumulation of lint in any area of the home can create a health
and fire hazard.
• Use only rigid metal or flexible metal 4-inch (10,2 cm) diameter
ductwork inside the dryer cabinet or for exhausting to the outside.
Use of plastic or other combustible ductwork can cause a fire.
Punctured ductwork can cause a fire if it collapses or becomes
otherwise restricted in use or during installation.
• Ductwork is not provided with the dryer, and you should obtain the
necessary ductwork locally. The end cap should have hinged
dampers to prevent backdraft when the dryer is not in use. Failure
to follow these instructions can result in fire or death.
• Exhaust air must not be discharged into a flue which Is used for
exhausting fumes from appliances burning gas or other fuels.
• The exhaust duct must be 4 inches (10.2 cm) in diameter with no
obstructions. The exhaust duct should be kept as short as possible.
Make sure to clean any old ducts before installing your new dryer.
Failure to follow these instructions can result in fire or death.
• DO NOT use sheet metal screws or other fasteners which extend
into the duct that could catch lint and reduce the efficiency of the
exhaust system. Secure all joints with duct tape. For complete
details, follow the Installation Instructions. Failure to follow these
instructions can result in fire or death.
• In the appliance enclosure or in the built-in structure, keep
ventilation opening clear of obstruction.
• Adequate ventilation has to be provided to avoid the back flow of
gases into the room from appliances burning other fuels, including
open fires Do not dry unwashed items in the tumble dryer.
ImPORTANT SAFETY INSTRUCTIONS
7 EN