Programing Mode - Setup Mode; Regular Price Setup - LG RV1329C1T El Manual Del Propietario

EN 24
PROGRAmmING mODE
PROGRAMMING MODE - Setup Mode
Setup Mode :
You can change dryer vend price, cycle time, and cycle parameters, etc.
how to enter Programming mode:
- Coin type – Turn on/off the toggle switch.
- Card type – Insert the service card.
- All types - Enter password.
1) Press the 1st & 3rd button at the same time.
2) Press the 2nd & 3rd buttons to toggle numbers.
Then, press the 4th button to move to the next digit.
3) Press the Start button to finish password input.
※ Default Password : 3000
1.

Regular Price Setup

This function sets the regular prices for all/each cycle.
Enter SVC Mode
Press 1st button
Press 2nd button
Press Start button
Press 2nd button or 3rd button
Press Start button
Select the price you want
Button functions :
Start button = Select
1st button = Go back a step
2nd button = Move up or Increase value
3rd button = Move down or Decrease value
Press Start to set the price
NOTE
• Range : 0,00~10,00
• Increments : 0,10
• ALL is to select the default prices for all the cycles at
once.
• Select individual price for COS1~4
• COS1 : High Temp
(display)
Regular Price Setup
Until display shows
Start button to select :
1st button to go back a step :
2nd button to move
3rd button to move
The next cycle setting will be displayed.
<Control Panel >
1st
2nd
3rd
4th
Start
up :
down :
• COS2 : Med Temp
• COS3 : Low Temp
• COS4 : No Heat
※ Individual cycle prices are prioritized above 'ALL' .
• Set your country from
Type Setup)
Display
(Refer to Currency