Portable Installation Instructions; Connect Fill-And-Drain Hose - Sears Kenmore 110.4443 Manual De Uso Y Cuidado

PORTABLE INSTALLATION
INSTRUCTIONS
Drain System
The washer must drain into a sink or laundry tub with
a carry-away capacity of 17 gal. (64.5 L) per minute
(for portable installations). The top of the tub must be
at least 27" (686 mm) above floor and no higher than
48" (121.9 cm) from the bottom of the washer.
(686 mm)
1.
Attach hose bracket
Slot
Post
Place the hose bracket over the post on the back of the washer
and position the the tab so it will insert into the slot. Push down
to lock into place.

Connect Fill-And-Drain Hose

Proper connection of the fill-and-drain hose will protect your
floors from damage due to water leakage.
2.
Insert new flat washer into inlet hose
Insert new flat washer (supplied) into the end of the inlet hose.
Firmly seat the washer in the coupling.
min.
27"
Coupling Washer
3.
Connect fill hose
Attach the fill hose to the cold water (left) inlet valve.
Tighten coupling by hand. Use pliers to make an additional
2/3 turn.
NOTE: Do not overtighten. Damage to the valves can result.
Hot water (right) inlet valve is capped. Leave this valve capped.
4.
Connect drain hose
¼
(6 mm)
To keep the fill-and-drain hose from leaking, it must be installed
according to the following instructions.
IMPORTANT: To ensure proper installation, this procedure must
be followed exactly.
Wet inside end of the drain hose with tap water.
IMPORTANT: Do not use any lubricant other than water.
Squeeze ears of double-wire clamp with pliers to open. Place
clamp over the straight end of the drain hose ¼" (6 mm) from
the end. Twist hose back and forth while pushing down onto
drain connector at the bottom of the washer. Continue until
hose contacts the cabinet.
Cap
Connect
hose
"
11