Rubi 54999 Instrucciones Originales página 8

8.
The blade can never touch the laser device. Be sure before
making the holes, that the dimension D is at least 5 mm.
Spirit level:
1. Make 1 hole of Ø20.5 mm. closer as possible to centre of the ma-
chine (fig.B-C).
4.BATTERIES REPLACEMENT (fig.1)
Switch off the laser device before any manipulation
Checks that the laser device is totally dry before open it.
Remove the laser device from its place.
Remove all 4 screws with a PH1 screwdriver (not included).
Remove the back cover and replace old batteries by the new ones
(2xAAA 1,5V). Place the batteries as shown in the back of the cover.
Never stares in front of the laser beam, it could be harmful
for your health.
Be sure that the O-ring is proper placed on the cover and that there is
no water inside the laser device.
Fix the 4 screws firmly.
Be careful when fixing the screws, tread can be damaged.
Check that the cover is placed properly, to assure the original water
tightness. The must touch the device's body and the O-ring must be
hide.
An improper manipulation will affects device's function
5.MAINTENANCE
Laser device:
Switch off the laser Device before any manipulation.
Check periodically that the laser device is not damaged. If it's
damaged, do not use it.
If beam's power diminishes replace the batteries as shown in point 4.
Clean the device with clean and slightly wet cloth. Do not use deter-
gents or solvents or any other cleaning product.
Check periodically that the laser device is fixed on the machine. If
not, follow point 3.
If water inside the device is supposed, disassemble it as shown
point 4.
Dry the device with a clean and dry cloth. Before assembly it again,
wait 2 hours to remove rest of humidity inside the device.