Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USE OF EXTENSION CORDS
Make sure the extension cord is in good condition before using. Always use the proper
size extension cords with the tool – that is, proper wire size for various lengths of cord and
heavy enough to carry the current the tool will draw. Use of an undersized cord will cause
a drop in line voltage resulting in loss of power and overheating. For proper size cords see
chart below.
Volts
120V
240V
Ampere Rating
More
Than
0
6
10
12
MOTOR
Be sure your power supply agrees with nameplate marking. 120 Volts AC only means
your tool will operate on standard 60 Hz household power. Do not operate AC tools on
DC. A rating of 120 volts AC/DC means that you tool will operate on standard 60 Hz AC or
DC power. This information is printed on the nameplate. Lower voltage will cause loss of
power and can result in over-heating. All Stanley FatMax tools are factory-tested; if this
tool does not operate, check the power supply.
FUNCTIONAL DESCRIPTION
1. Two speed switch
2. Hang hole
3. Air vents
4. Hot air nozzle
5. Temperature adjustment knob
Tool Operation
SWITCH - FIGURE B
The position of the switch controls both the fan speed and the heat output of the gun.
There is considerable overlap in the temperature ranges with the use of the temperature
adjustment knob.
• To turn the tool on in low air speed, low heat, slide the switch (1)
to the position marked "I".
• To turn the tool on in high air speed, high heat , slide the switch
(1) to the position marked "II".
• To turn the tool off, slide the switch (1) to the position marked "0".
Minimum Gauge for Cord Sets
Total Length of Cord in Feet
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
Than
-
6
18
-
10
18
-
12
16
-
16
14
26-50
51-100
51-100
101-200
American Wire Gage
16
16
16
14
16
14
12
Not Recommended
A
4
6
101-150
201-300
14
12
12
5
1
2
B
1
3
Tabla de contenido
