Tabla de contenido
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
• PANPOT changes the value for the melody voice and rhythm voice in
relation to the preset value.
• Portamento time is fixed to 0 when the PORTAMENTO CONTROL is
used.
• HARMONIC CONTENT applies adjustment to the resonance value that
is set by the voice. This parameter specifies relative change with the
value of 64 producing 0 adjustment. As values get higher the sound
becomes increasingly eccentric. Note that for some voices the effective
parameter range is narrower than the legal parameter range.
• RELEASE TIME applies adjustment to the envelope release time set by
the voice. This parameter specifies relative change with the value of 64
producing 0 adjustment.
• ATTACK TIME applies adjustment to the envelope attack time set by the
voice. This parameter specifies relative change with the value of 64
producing 0 adjustment.
• BRIGHTNESS applies adjustment to the cut-off frequency set by the
voice. This parameter specifies relative change with the value of 64
producing 0 adjustment. Lower voices produce a softer sound. For
some voices the effective parameter range is narrower than the legal
parameter range.
(3-2) CHANNEL MODE MESSAGES
STATUS
CONTROL NUMBER 0ccccccc
CONTROL VALUE
(3-2-1) ALL SOUND OFF (Recive only)
Switches off all sound from the channel. Does not reset Note On and Hold On
conditions established by Channel Messages.
(3-2-2) RESET ALL CONTROLLERS (Recive only)
Resets controllers as follows.
PITCH BEND CHANGE
AFTER TOUCH
MODULATION
EXPRESSION
SUSTAIN
SOSTENUTO
SOFT PEDAL
NRPN
RPN
PORTAMENT CONTROL
PORTAMENTO
(3-2-3) ALL NOTES OFF (Recive only)
Switches off all of the channel's "on" notes. However, any notes being held by SUSTAIN
or SOSTENUTO continue to sound until SUSTAIN/SOSTENUTO goes off.
(3-2-4) OMNI OFF (Recive only) (CONTROL NUMBER = 7CH , DATA VALUE = 0)
Same processing as for All Notes Off.
(3-2-5) OMNI ON (Recive only) (CONTROL NUMBER = 7DH , DATA VALUE = 0)
Same processing as for All Notes Off. Omni On is not executed.
(3-2-6) MONO (Recive only) (CONTROL NUMBER = 7EH , DATA VALUE = 0)
Same processing as for All Notes Off. If the 3rd byte is in a range of 0-16 the
corresponding channel will be changed to Mode 4 (m=1).
(3-2-7) POLY (Recive only) (CONTROL NUMBER = 7FH , DATA VALUE = 0)
Same processing as for All Sounds Off and the corresponding channel will be
changed to Mode 3.
(3-3) REGISTERED PARAMETER NUMBER(RPN)
STATUS
RPN LSB
RPN LSB NUMBER 0ppppppp
RPN MSB
RPN MSB NUMBER 0qqqqqqq
DATA ENTRY MSB 00000110(06H)
DATA VALUE
DATA ENTRY LSB
DATA VALUE
Downloaded from:
http://www.usersmanualguide.com/
1011nnnn(BnH)
n = 0 - 15 VOICE CHANNEL NUMBER
c = CONTROL NUMBER
0vvvvvvv
v = DATA VALUE
(CONTROL NUMBER = 78H , DATA VALUE = 0)
(CONTROL NUMBER = 79H , DATA VALUE = 0)
0 (Center)
0 (min.)
0 (min.)
127 (max.)
0 (off)
0 (off)
0 (off)
Sets number to null. (Internal data remains unchanged)
Sets number to null. (Internal data remains unchanged)
Resets portamento source note number
0 (off)
(CONTROL NUMBER = 7BH , DATA VALUE = 0)
1011nnnn(BnH)
n = 0 - 15 VOICE CHANNEL NUMBER
01100100(64H)
p = RPN LSB(refer to the list below)
01100101(65H)
q = RPN MSB(refer to the list below)
0mmmmmmm
m = Data Value
00100110(26H)
0lllllll
l = Data Value
First appoints the parameter for RPN MSB/LSB, then sets the parameter value for
data entry MSB/LSB.
RPN
D.ENTRY
LSB MSB MSB LSB PARAMETER NAME
00H 00H
mmH —
PITCH BEND SENSITIVITY 00H - 18H (0 - 24 semitones)
01H 00H
mmH llH
FINE TUNE
02H 00H
mmH —
COARSE TUNE
7FH 7FH —
—
NULL
Clears the current RPN number setting. Does not change the internal parameter settings.
(3-4) NON-REGISTERED PARAMETER NUMBER(NRPN) (Recive only)
STATUS
1011nnnn(BnH)
NRPN LSB
01100010(62H)
NRPN LSB NUMBER 0ppppppp
NRPN MSB
01100011(63H)
NRPN MSB NUMBER 0qqqqqqq
DATA ENTRY MSB
00000110(06H)
DATA VALUE
0mmmmmmm
First appoints the parameter for NRPN MSB/LSB, then sets the parameter value for data entry
MSB/LSB.
NRPN
D.ENTRY
MSB LSB MSB LSB PARAMETER NAME
01H 08H
mmH —
VIBRATO RATE
01H 09H
mmH —
VIBRATO DEPTH
01H 0AH mmH —
VIBRATO DELAY
01H 20H
mmH —
FILTER CUTOFF FREQUENCY 00H - 40H - 7FH (-64 - 0 - +63)
01H 21H
mmH —
FILTER RESONANCE
01H 63H
mmH —
EG ATTACK TIME
01H 64H
mmH —
EG DECAY TIME
01H 66H
mmH —
EG RELEASE
14H rrH
mmH —
DRUM FILTER CUTOFF FREQ. 00H - 40H - 7FH (-64 - 0 - +63)
15H rrH
mmH —
DRUM FILTER RESONANCE
16H rrH
mmH —
DRUM AEG ATTACK RATE 00H - 40H - 7FH (-64 - 0 - +63)
17H rrH
mmH —
DRUM AEG DECAY RATE
18H rrH
mmH —
DRUM PITCH COARSE
19H rrH
mmH —
DRUM PITCH FINE
1AH rrH
mmH —
DRUM LEVEL
1CH rrH
mmH —
DRUM PANPOT
1DH rrH
mmH —
DRUM REVERB SEND LEVEL 00H - 7FH (0 - max.)
1EH rrH
mmH —
DRUM CHORUS SEND LEVEL 00H - 7FH (0 - max.)
1FH rrH
mmH —
DRUM VARIATION SEND LEVEL 00H - 7FH (0 - max.)
The MSG14H-1FH (for drums) message is accepted as long as the channel is set with a drum
voice.
rrH : drum instrument note number
(3-5) SYSTEM REALTIME MESSAGES
(3-5-1) MIDI CLOCK
STATUS
11111000 (F8H)
Transmission: 96 clocks per measure are transmitted.
Reception: If the instrument's clock is set to external, after FAH is received from the
external device the instrument's clock will sync with the 96 beats per measure
received from the external device.
Decides whether the internal clock, or Timing Clocks received via the MIDI IN will
be used.
(3-5-2) START
STATUS
11111010 (FAH)
Transmission: Transmitted when instrument's Rhythm or Song playback is started.
Reception: Depending upon the condition, Rhythm, Song Playback, or Song Rec will
start.
(3-5-3) STOP
STATUS
11111100 (FCH)
Transmission: Transmitted when instrument's Rhythm or Song playback is stopped.
Reception: Depending upon the condition, Rhythm, Song Playback, or Song Rec will
stop.
(3-5-4) ACTIVE SENSING
STATUS
11111110 (FEH)
Transmission: Transmitted approximately once every 200msec.
Reception: Sensing is started once this Code is received. If Status or Data is not
received within 400ms, the MIDI Receive Buffer will be cleared, and all notes,
including those being sustained, will be cut OFF. Also, all control values will be reset
to their factory defaults.
DATA RANGE
{mmH,llH} = {00H,00H} - {40H,00H} - {7FH,7FH}
(-8192*100/8192) - 0 - (+8192*100/8192)
28H - 40H - 58H (-24 - 0 - +24 semitones)
n = 0 - 15 VOICE CHANNEL NUMBER
p = NRPN LSB(refer to the list below)
q = NRPN MSB(refer to the list below)
m = Data Value
DATA RANGE
00H - 40H - 7FH (-64 - 0 - +63)
00H - 40H - 7FH (-64 - 0 - +63)
00H - 40H - 7FH (-64 - 0 - +63)
00H - 40H - 7FH (-64 - 0 - +63)
00H - 40H - 7FH (-64 - 0 - +63)
00H - 40H - 7FH (-64 - 0 - +63)
00H - 40H - 7FH (-64 - 0 - +63)
00H - 40H - 7FH (-64 - 0 - +63)
00H - 40H - 7FH (-64 - 0 - +63)
00H - 40H - 7FH (-64 - 0 - +63)
00H - 40H - 7FH (-64 - 0 - +63)
00H - 7FH (0 - max.)
00H ,01H - 40H - 7FH
(random,left - center - right)
CVP-98/96/600
11
Tabla de contenido
