Connect Hose And Water Supply To Pump - Briggs & Stratton BPW4000 Manual Del Usuario

Connect Hose and Water Supply to Pump

Figure
3
NOTICE Inspect high pressure hose for cuts, leaks or
damage.
1. Pull back on collar of high pressure hose (D), slide onto
spray gun (A) and release collar. Tug on hose to make
sure it is secure.
2. Pull back collar on other end of hose and slide onto
outlet (R) on pump and release collar. Tug on hose to
make sure it is secure.
3. Inspect inlet screen before connecting garden hose to
water inlet (N). Clean screen if it contains debris or
replace if damaged. DO NOT run pressure washer if
inlet screen is damaged.
4. Make sure water source is capable of supplying water
at a flow rate greater than 18.9 liters (5.0 gallons) per
minute and 0.14-0.55 MPa (20-80 PSI) at pressure
washer end of garden hose.
5. Run water through garden hose to clean out debris.
NOTICE Use ONLY cold water (less than 38°C (100°F)).
NOTICE Using a backflow preventer at pump inlet could
cause pump damage. There MUST be at least 3 m (10 ft.)
of unrestricted garden hose between pressure washer inlet
and backflow preventer.
WARNING Water that has flowed through a backflow
preventer is considered to be non-potable.
6. Connect garden hose (not to exceed 15 m (50 ft.)) to
water inlet and tighten.
7. Turn ON water, press red button on gun, and squeeze
trigger to purge system of air. Replace gun if trigger
does not lock.
8. Attach nozzle extension (E) to gun (A) and tighten.
9. Pull back on collar of nozzle extension, insert spray
tip and release (W). Tug on spray tip to make sure it is
securely in place.
Start Pressure Washer Figure
NOTICE DO NOT run pump without water supply
connected and turned on.
1. Rotate fuel shut-off valve (G) to ON (
counter-clockwise).
2. Move throttle control lever (H) to FAST (
shown on engine as a rabbit.
3. Move choke lever (F) to CHOKE (
NOTICE For a warm engine, be sure choke lever is in
RUN ( ) position.
WARNING! Starter and other rotating parts could
entangle hands, hair, clothing, or accessories
resulting in serious injury. NEVER operate pressure
washer without protective housing or covers. DO NOT
wear loose clothing, jewelry or anything that could be
caught in the starter or other rotating parts. Tie up long hair
and remove jewelry.
6
NOTICE Before starting pressure washer, be sure you
are wearing safety goggles and protective clothing.
safety goggles marked to comply with ANSI Z87.1 when
using or in vicinity of this equipment. Always wear protective clothing such as a long-sleeved shirt, long pants
and close-toed shoes.
7. When starting engine, grasp recoil handle and pull
fractures, bruises, or sprains resulting in serious injury.
NEVER pull starter cord without first relieving spray gun
pressure. When starting engine, pull cord slowly until
resistance is felt and then pull rapidly to avoid kickback.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
8. Return recoil handle slowly. DO NOT let rope "snap
9. After each starting attempt, where engine fails to
10. When engine starts, slowly move choke lever to RUN
NOTICE Always keep throttle lever in FAST (
when operating pressure washer.
3
possible amputation. If cut by fluid, call physician
immediately. DO NOT treat as a simple cut. DO NOT allow
CHILDREN to operate pressure washer. NEVER aim spray
) position (fully
gun at people, animals, or plants. DO NOT secure spray
gun in open position. DO NOT leave spray gun unattended
) position,
while machine is running. NEVER use a spray gun which
does not have a trigger lock or trigger guard in place and in
) position.
working order. NEVER connect high pressure hose to
nozzle extension.
to cool before touching.
Spray Tips Figure
Spray tips can be changed while pressure washer is
running once spray gun trigger is locked.
WARNING! Spray could splash back or
propel objects resulting in serious injury.
Always wear indirect vented (chemical splash)
slowly until you feel some resistance. Then pull rapidly
to start engine.
WARNING! Starter cord kickback (rapid retraction)
will pull hand and arm toward engine faster than you
can let go which could cause broken bones,
back" against starter.
run, point gun in safe direction, press red button and
squeeze trigger to release high pressure.
( ) position, as engine warms. If engine falters, move
choke lever to CHOKE (
position.
WARNING! The high pressure stream of water that
this equipment produces could cut through skin and
its underlying tissues, resulting in serious injury and
WARNING! Contact with muffler area could cause
burns resulting in serious injury. DO NOT touch hot
parts and AVOID hot exhaust gases. Allow equipment
WARNING! Contact with power source could cause
electric shock or burn resulting in death or serious
injury. NEVER spray near power source.
11
BRIGGSandSTRATTON.COM
) position, then to RUN (
) position
)