Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TEchNical fEaTurEs
Tension .................................. See data plate
Motor power .....................................1100 W
Noise level...................................... 62 dB(A)
Depression ................................210 mmH
Paper bag capacity .................................12 l
Dimensions ............... 390 x 340 x 290H mm
Weight .................................................4.6 kg
Accessories ....................................Ø 32 mm
TYPE Of usE
This unit must solely be used to vacuum
dust, crumbs, etc. as it is designed solely for
this purpose.
haZarD:
The manufacturer cannot be held liable
for any damage caused by improper or
incorrect use.
any other use relieves the Manufacturer
from all responsibility of damage caused
to persons and/or things and renders the
warranty null and void.
iNcOrrEcT usE
Do not use the unit to:
-
vacuum any type of liquid;
- vacuum flammable, explosive, corrosive
and toxic substances.
-
vacuum hot substances.
Do not use the unit in explosive atmos-
pheres.
PrEPariNG ThE uNiT
Checking the filter systems
-
Release the levers (1 Fig.1) and remove
the cover (2 Fig.2) complete with the mo-
tor unit and cartridge filter (3 Fig.2).
-
Check that the paper filter bag (4 Fig.3) is
in place inside the device.
-
If the paper filter bag (4 Fig.3) is not
present, insert it by putting the square
cardboard stiffener into the slot in the
drum.
-
Replace the cover and lock it using the
O
levers (1 Fig.1).
2
assembling the pipes
-
Insert the sleeve with bayonet connection
(5 Fig.4) into the hole (6 Fig.4) in the con-
tainer, aligning the connections present
in the sleeve with the slots (7 Fig.4) in
the hole in the container, then rotate the
sleeve clockwise to lock it.
-
Hook the rigid extensions (8 Fig.5) to the
ergonomic handle (9 Fig.5) of the flexible
pipe.
-
Attach the desired accessory (floor tool,
dusting brush, crevice tool, multi-purpose
brush etc.) to the suction tube (9 Fig.5)
using the telescopic tube
-
The length of the telescopic tube (20 Fig.
16) can be adjusted as follows:
-
To lengthen the tube, press down on the
ring nut (21 Fig. 16) and simultaneously
extract the top part (22 Fig. 16) of the
tube. Once the required length has been
obtained, release the ring nut (21 Fig. 16)
the tube will lock into the nearest locking
position;
-
To shorten the telescopic tube, use one
hand to push the ring nut (21 Fig. 16)
down and the other to reinsert the top
tube (22 Fig. 16) into the lower sleeve (23
Fig. 16).
Multi-purpose brush
The multi-purpose brush should be used as
follows:
-
To clean hard floors, parquet etc. press
the lever back (10 Fig.6) to remove the
bristles from the brush.
-
To vacuum on carpets, rugs etc. press
the lever forward (10 Fig.6) to retract the
brush bristles.
EN - 1
EN
Tabla de contenido
