Operating The Leaf Blower - Grizzly BLS 30 Traducción Del Manual De Instrucciones Original

Operating the leaf blower

Danger of injury.
Wear suitable clothing and
work gloves when working with
the device. Make sure that the
device is functioning properly
before every use. Make sure that
the collection bag and the tube
are assembled correctly and the
carrying strap is adjusted cor-
rectly for work.
Note noise protection laws and local
regulations. The use of the device can
be restricted or prohibited on certain
days (e.g. Sundays and holidays),
during certain times of the day (lunch
hours, at night) or in special areas
(e.g. health resorts, clinics etc. ).
After switching off the device,
the impeller wheel continues to
rotate for some time. Danger of
injury due to rotating tool.
Fill with Fuel
Always ensure good ventilation
when handling fuel.
Do not smoke when refuelling and
keep away from any heat sources.
Never refuel with the motor run-
ning or hot.
Open the filler cap carefully, so any
excess pressure that is present
can escape slowly.
Do not start the equipment near
the filling location.
Use suitable and authorised con-
tainers for storing the fuel.
There is a risk of fire or explosion
in case of non-observance.
Only use the fuel mix recommend-
ed in the instructions. This must
not be older than 3 months. In
case of non-observance, the motor
may be damaged and the guaran-
tee will be invalidated.
Avoid direct skin contact with pet-
rol and inhalation of petrol fumes.
They are hazardous to health!
The equipment is run with a
mix of unleaded petrol and
two-stroke engine oil (qual-
ity API TC) in the ratio 40:1.
• Never use undiluted fuel. Use
only two-stroke engine oil (no four-stroke
engine oil or oil for water cooled motors).
In case of non-observance, the motor may
be damaged and the guarantee will be
invalidated.
1. Mix the petrol and oil in a clean con-
tainer that is designed for petrol.
2. Initially pour in half of the petrol then
the entire oil quantity and shake the
container. Add the rest of the petrol
then shake again.
3. Unscrew the filler cap and pour the
fuel mix into the petrol tank. Wipe off
petrol residues around the filler cap
and close the filler cap.
Start the Motor
1. Place the equipment on a firm, even
base.
2. To switch on the ignition, push the on/
off switch (3) to position I.
3. For a cold start, push the choke lever
(7) to the snowflake symbol.
4. Press the fuel pump (primer) (8) 6 x.
5. Pull the starter cable on the starter
handle (6) until the motor starts.
GB
87