Assembly Instructions - Grizzly BLS 30 Traducción Del Manual De Instrucciones Original

GB

Assembly instructions

Remove the power plug before all
work on the device. Employ only
original parts. Danger of injury.
Before putting the device into op-
eration, the blower / suction tube
must be completely mounted and
screwed tight and the collection
bag and carrying strap must be
attached.
Mounting of blower / suction tube:
Make sure the tubes are held
straight during mounting. The elec-
trical contacts in the tube could be
damaged.
First connect the lower blow/suction tube
to the upper blow/suction tube.
Loosen screws C on the lower end of the
upper blow/suction pipe.
Push the lower blow/suction pipe into the
upper blow/suction pipe. Place the lower
blow/suction pipe slightly askew on the
upper, round pipe section of the upper
blow/suction pipe and press to tilt it into
the upper blow/suction pipe. Refix screws
C in place.
Connect the now pre-assembled blow/
suction tube to the leaf blower motor part.
To do this, remove screws A and loosen
screws B.
Push the upper blow/suction pipe into the
machine housing.
86
Place the upper blow/suction pipe slightly
askew on the upper, round part of the
housing and press to tilt it into the ma-
chine housing.
Reposition screws A and fix all screws (A
and B) in place.
Mount flat suction nozzle:
1. To work with the flat suction nozzle
(1), push it onto the suction opening
on the tube.
To remove the nozzle pull the nozzle
out of the tube.
B
Adjust Floor Clearance:
2. To adjust the floor clearance of the
flat suction nozzle (1), pull the wheels
outwards and turn the wheels to the
next lock-in position. There are three
possible lock-in positions. Use a posi-
tion of equal height on both sides of
the flat suction nozzle.
Mount collection bag:
3. Place the retainer frame onto the
opening on the motor components so
that the grip points towards the mains
cable. Press the retainer frame over
the engagement strip until the cou-
pling lever engages.
Suction operation is only per-
missible with the collection bag
mounted.
4. Connect the collection bag retainer
loop (12) to the blower / suction tube.
Mount carrying strap:
5. Hook the carrying strap onto the at-
tachment bar (4).