Blendtec STEALTH Manual Del Usuario página 12

of the cabinet space.
• If installing more than one blender, allow 16" (40.6 cm) of
center-to-center blender spacing.
• Cut a hole in the countertop 4 ⅜" (11.1 cm) wide and 5 ⅞"
(14.9 cm) long (see the countertop hole template in Appendix
A). Ensure that the 4 ⅜" (11.1 cm) sides are parallel with the
machine operator.
Note: Double check to ensure that all space requirements and
measurements are correct BEFORE cutting.
• Place blender into the countertop; ensure the gasket is flat
against the counter surface.
3.2.3 CONNOISSEUR MODELS INTERFACE
Preprogrammed Cycle Buttons
Note: Power switch is located on the front of the Connoisseur 825
Preprogrammed Cycles
Preprogrammed cycles run at varying speeds and durations, and
automatically stop. To start a cycle, press any preprogrammed
button. Press any cycle again to end that cycle. Hold
To program different cycles, see section 3.2.6 of this manual.
10
3.2.4 ADVANCED PROGRAMMING AND DIAGNOSTICS
Menu navigation tips
1. Press
2. Press
3. To return to the main menu from any submenu area, tap the
until the main menu screen appears.
3.2.5 SELECTING THE DESIRED PROFILE
1. Press
2. Press
3. Press
4. Press
5. Press
3.2.6 CHANGING PREPROGRAMMED CYCLE BUTTONS
Temporarily change cycle buttons
1. Press
2. Press
to select.
3. Choose Standard Blend Cycles or Custom Blend Cycles.
4. Choose the desired blend cycle*.
Pulse
5. Select the button to use for this blend cycle change, then
press
*To temporarily disable a button, select "Disable button" at
this step.
Note: After customizing a cycle to a number button, an asterisk will
appear after the profile name when returning to operation mode.
Loading a new profile on the blender will reset the profiles back to
to pulse.
default cycle buttons.
and for one second.
to scroll down and to select the desired function.
and for one second to enter the menu.
to scroll down to Profiles menu; press
to scroll to desired category; press
to scroll to desired profile and press
to activate profile. To cancel selection, press 'pulse'.
and for one second to enter the menu.
to scroll down to Blend Cycles, then press
. To cancel selection press
to select.
to select.
to select.
.