Full Auto Wireless Master Unit (E-Ttl, Master Canon) - Rollei 56 Manual De Instrucciones

Note:
62
• The SLAVE flash should have the same setting as the MASTER unit if the Canon
flash is used as MASTER mode .
• The Canon Flash Unit needs to have the same group A power as the MASTER
model power .
• The MASTER mode supports high-speed synchronous but does not support rear
curtain sync .

Full Auto Wireless MASTER Unit (E-TTL, MASTER Canon)

Press the [Flash mode select button] on the MASTER flash . There you can set the
MASTER light as Auto E-TTL mode to auto flash shooting .
1 . Press [button A] to set Canon as MASTER unit .
2 . Press [Flash mode select button] to set up
E-TTL model .
3 . Press the [wireless setting button] until (RATIO
OFF) will be highlighted .
4 . Select flash light ratio .
Press the left and right button to set the flash
light ratio: <RATIO OFF >,<RATIO A: B> or
<RATIOA: B C> .
<RATIO OFF> means three SLAVE unit groups
will have the same bright output as the master
light . <RATIO A: B> means that the groups A/B will flash and that the output
bright ratio will be set for the groups A B .
<RATIO A: B C> means three groups will flash and the output bright ratio will
be set for the groups A B and group C is the power compensation .
5 . Set the flash light ratio <RATIO A: B> or <RATIO A: B C> . Press the [button A] to
<RATIO A: B> and flash light ratio will be highlighted . Press the left and right
button to set up the flash light ratio and all kinds of codes as shown next page .
ENGLISH