Troubleshooting; Machine Disposal - Viper AS430B Manual Del Usuario

Ocultar thumbs Ver también para AS430B:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 94
ENGLISH

TROUBLESHOOTING

Breakdown
Machine not working:
Indication light not on
Warning light (39 and 40)
flashing
Brush not working
Vacuum motor not working
Inadequate Vacuum
Pure water supply to the brush
inadequate
Squeegee leaving marks
NOTE
If the machine is installed with the optional on-board charger, and when the on-
board charger is defective, the machine cannot be operated.
If the on-board charger is defective, please contact the authorised maintenance
center.
To find out more information, please refer to the maintenance manual (available at
any maintenance center of VIPER)

MACHINE DISPOSAL

Use qualified crushing machine to destroy this machine.
Before destroying this machine, please take away and segregate the following materials which,
according to related laws and regulations, must be properly processed.
- Battery
- Brush/pad-holder
- Plastic hoses and plastic components
- Electrical and electronic components(*)
(*): Please contact the nearest VIPER Center (especially when scrapping of electrical and electronic
components is required).
USER MANUAL
Probable Causes
Battery connector (9) not connected.
Battery power already exhausted
Brush motor overloaded
Other matters jam the rotating of the
brush
Brush fuse trip off
Belt slipping
Vacuum fuse trip off
Wastewater tank is full.
Vacuum tube for waste and squeegee
not properly connected
Float filter blocked or inlet blocked
Squeegee dirty or squeegee blade worn
and damaged
Recovery tank lid not properly turned
on, or the sealing strip of the water tank
damaged
Filter dirty.
Debris
like
fragments
squeegee blade
Squeegee blade already worn, cracked,
brittle.
Balance of squeegee not adjusted
Connect the battery connector
Charge the battery
Change to a soft brush to adapt to
the floor being cleaned
Clear up the brush
Reset
Check belt, adjust tension pulley
Reset
Drain the water tank
Connect the Vacuum tube for waste
and the squeegee
Clean the float filter, check the float
ball
Clean and check the squeegee
Refit on the lid properly, or change
the water tank sealing strip
Clean the filter
under
the
Remove the fragments
Change the squeegee blade
Adjust the balance
18
Remedies
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

As510b

Tabla de contenido