Accessories/Options; Troubleshooting; Scrapping - Viper AS5160 Manual Del Usuario

USER MANUAL

ACCESSORIES/OPTIONS

In addition to the standard components, the machine can be equipped with the following accessories/options,
according to the machine specific use:
For further information concerning the above-mentioned optional accessories, contact an authorized Retailer.
ACCESSORIES/OPTIONS
See "Parts List" section
1. GEL/AGM batteries
2. Pads of different materials

TROUBLESHOOTING

Trouble
The motors do not work; no
warning light turns on.
The machine does not move
(Only for machine with trac-
tion)
The 3 battery charge indicators
are flashing simultaneously.
The brushes do not work, the
red warning light is on.
The recovery water vacuuming
is insufficient.
The solution flow to the brush-
es is insufficient.
The squeegee leaves marks on
the floor.
NOTE
Machine with battery charger installed, cannot operate if the charger is not on board. In case of
battery charger malfunction, contact an authorized Service Center.
For further information refer to the Service Manual, available at any Service Center.

SCRAPPING

Scrap the machine by the qualified waste treatment institution.
Before the machine is scrapped, please take away and segregate below subassembly that relevant laws and regula-
tions request must be disposed in appropriate way.
-
Battery
-
Brush/Pad-holder
-
Plastic hose and plastic parts
-
Electrical and electronic components (*)
(*) Please contact our company service center for any destroy of electrical and electronic components.
Probable causes
The battery connector is disconnected.
The batteries are completely discharged.
The machine has been turned on by using the igni-
tion key and by keeping one of the switches
pressed.
Brush motor overload.
Foreign materials (tangled threads, etc.) which may
prevent the brush from rotating.
The batteries are discharged.
The recovery water tank is full.
The hose is disconnected from the squeegee.
The vacuum grid is clogged or the float is
stuck closed.
The squeegee is dirty or the squeegee blades
are worn or damaged.
The tank cover is not properly closed, or the gasket
is damaged, or the Bend tube is clogged.
The recovery water tank is dirty.
The solution/clean water filter is dirty.
There are debris under the squeegee blades.
The squeegee blades are worn, chipped or torn.
The squeegee has not been adjusted with the knob.
Connect the battery connector.
Charge the batteries.
Turn the ignition key to "0", then try to
start the machine again without pressing
the switches.
Use less aggressive brushes
Clean the brush hub.
Charge the batteries.
Empty the tank.
Connect.
Clean the grid or check the float.
Clean and check the squeegee.
Close the cover correctly, or replace the
gasket or clean the Bend tube.
Clean.
Clean the filter.
Remove the debris.
Replace the blades.
Adjust.
27
ENGLISH
Remedy