Fermax 1088 Manual De Instrucciones página 34

INTERFACE TELEFONICO
INTERFACE TELEFONICO
PROGRAMMING INSTALLATION PARAMETERS
Installation Parameters are configured when the Interface is installed and are not usually modified
afterwards. The following table shows some of these parameters.
Digit Parameter
House number (ADS Number)
0
Number the panel identifies Interface with.
Open door timing
2
Time door release mechanism is activated.
Relay timing
5
Time relay is activated.
Ring pattern(Call type)
6
Number of tones heard at telephone when call is received.
When entering the Open Door Timing, the Relay Timing or Ring Tone, we take the following table into
account:
Parameter
Open door timing
Relay timing
Ring tone
The system can be programmed from any telephone connected to the Interface. To do so:
1- Unhook the telephone handset you are going to program the Interface from.
Dialling tone sounds.
2- Press three times the '#' key.
Now the PRG LED lights up and the dialling tone stops.
3- On the telephone, press the digit corresponding to the parameter you want to program.
4- Use the keypad to input the new value.
The green LED lights up every time you press a key.
5- Press '#' (once) again to exit programming mode.
Or wait 30 seconds without pressing any keys.
√ √ √ √ √ NOTES:
The Telephone Interface must be connected to the telephone line for programming.
•
The Ring Pattern may be changed to make it easier to distinguish when a door control call is received
•
and when it is a normal telephone call.
12
Value entered
N (1....200)
N (1......60)
N (1.....10)
Value
1-199
1-200
1-60
1-10
Equivalent time
t= N / 4 sec.
t= N / 2 sec.
t=N sec.
System
ADS
4+N
BOTH
BOTH
Default
4 sec.
2.5 sec.
1 sec.