Installing An Ac Or Dc Power Supply - Dell Networking S6000 Guía De Introducción

Installing an AC or DC Power Supply

To install an AC or DC power supply, follow these steps.
NOTE: The PSU slides into the slot smoothly. Do not force the PSU into a slot as
this may damage the PSU or the S6000 chassis.
NOTE: Ensure that the PSU is correctly installed. When the PSU is correctly
installed, the power connector is on the left side of the PSU and the status LED is at
the bottom of the PSU.
NOTE: If you use a single PSU, install a blank plate in the other PSU slot. Dell
Networking recommends using power supply 1 (PSU1) as the blank plate slot.
Step Task
Remove the PSU slot cover from the S6000 (the PSU side of switch). You may
1
select either of the two PSU slots.
Remove the PSU from the electro-static bag.
2
Insert the PSU into the switch PSU slot (insert the PSU exposed PCB edge
3
connector first).
The PSU slot is keyed such that the PSU can only be fully inserted in one
orientation.
1 - Slot 1
2 - PSU1
When the PSU is installed correctly, it snaps into place and is flushed with the
back of the switch.
18
Installation