Connecting A N20Xx Switch To A Power Source; Ac And Dc Power Connection - Dell N20 Serie Guía De Introducción

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 274
3 Connect the RJ-45 connector on the cable directly to the switch console
port. The Dell Networking console port is located on the right side of the
front panel and is labeled with a |O|O| symbol, as shown in Figure 1-10
on page 22.
NOTE:
serial port via the local CLI. Only one serial console session at a time is
supported.
Figure 1-10. N2024P Front Panel with Console Port

Connecting a N20xx Switch to a Power Source

CAUTION:
manual as well as the safety information for other switches that connect to or
support the switch.
All N20xx models have one internal power supply. The power receptacles are
on the back panel.

AC and DC Power Connection

1 Make sure that the switch console port is connected to a VT100 terminal
or VT100 terminal emulator via the RJ-45 to DB-9 female cable.
2 Using a 5-foot (1.5 m) standard power cable with safety ground connected,
connect the power cable to the AC main receptacle located on the back
panel (see Figure 1-11 on page 23).
3 Connect the power cable to a grounded AC outlet.
22
Getting Started Guide
Serial console access to the stack manager is available from any
Read the safety information in the Safety and Regulatory Information
Console Port
Tabla de contenido
loading

Este manual también es adecuado para:

N30 serie

Tabla de contenido