HoMedics enviraScape Manual De Instrucciones página 5

IB-WFLMWALL-1110-01_Layout 1 17/12/2010 12:27 Page 5
5. Insert LIGHT BULB (E) into the light clip located inside the BASE (A) (Fig. 4).
Warning: Bulb gets very hot, allow to cool before handling.
6. Insert PUMP (B) outlet into the water tube. The FOUNTAIN TOP (C) should stand on the base
securely (Fig 5).
7. Place the cord through the cord slot on the bottom of BASE (A) (Fig. 6).
8. Fill BASE (A) with clean water until the water level reaches top of light clip. Place RIVER
ROCKS (D) on platform for decoration.
9. Plug cord into 230V-240V household outlet. The fountain is controlled by the switch located
on the power cord, if pump does not operate, rotate in-line switch once to turn "on" and once
more "off".
Note: Ensure that the electrical cord loops below the electrical outlet to form a 'Drip loop'.
This will prevent water from running down the cord into the electrical outlet (Fig 8).
Fig. 3
Flat Surface
Base
Fig. 5
Pump outlet
Fig. 7
Clean Water
River Rocks
Fig. 4
Light Bulb
Fig. 6
Water Tube
Fig. 8
Adaptor
Switch
5
Light Clip
Cord Slot
Drip Loop