KRESS 108 AS 1,3 Manual Original página 25

Operation
If you notice that you have to charge the battery
more and more frequently, it is spent and must be
replaced.
Observe the instructions for disposal.
Workplace lighting (optional)
The lamp 7 allows you to cast more light on your
working area where lighting conditions are unfa-
vourable.
The lighting switches on automatically when you
press the On/Off switch VI.
If the rotational direction switch V is in centre po-
sition, the lamp can be used without rotational
movement of the driver.
Battery charger
Observe correct mains voltage!
Before putting the tool into operation, check that
the mains voltage and frequency on the type plate
match the details of your mains supply.
Mains cable charger
Fixed power supply
Fixed power supply
Damaged mains cables must not be used. They
must be replaced immediately by an expert tech-
nician.
Specified conditions of use for the
charger
The charger is intended solely for charging Kress
batteries.
Ensure that you use the right batteries for the
charger, see "Appropriate batteries".
Symbols
Battery fully charged
Battery is charging
Battery is flat
Use KRESS batteries!
Operation IFC-HT14V-...
Batteries used
IFC-HT14V-10.8A
Li ion battery with a rated voltage
of 10.8 V d.c.
Batteries used
IFC-HT14V-14.4
Li ion battery with a rated voltage
of 14.4 V d.c.
Batteries used
IFC-HT14V-18
Li ion battery with a rated voltage
of 18 V d.c.
Charging the battery
Only put original batteries into the battery
charger!
 Plug the charger into the mains.
The LED lights up green.
The LED lights up green. Charger
ready for operation.
 Push the battery into the charger as far as the
stop.
Red and green LEDs light up - charg-
ing in process.
During the charging process, both the
battery and the charger heat up.
Red - green flashing light - battery is
charged, charger has switched to
trickle charge.
Unplug the charger from the mains if the
charger is unattended.
Charging not possible
LEDs flash red and green.
Battery is too hot or too cold.
The charging process begins automatically as
soon as the battery reaches a temperature within
the permissible range.
Short-circuiting between the charging contacts.
English 25
EN
AkkuBS_CN-EN / 1004