KRESS 108 AS 1,3 Manual Original página 23

Operation
Battery
Rated voltage of battery in V DC
Capacity in Ah
Nickel-cadmium battery
Nickel-metallic hydride battery
Battery with lithium-ion technology
Battery charger
Mains voltage in V~ / Frequency in
Hz
Charging voltage in V DC.
Charging current in A
Trickle charge in mA
Operating temperature range in °C
XX
Battery charging time in min.
Your battery charger is double-insu-
lated in accordance with EN 60335.
For this reason an earth wire is not
required.
The device is suppressed against radio and TV
broadcasts, in accordance with EN 55014-1 and is
immune to disturbances in accordance with EN
55014-2.
4. Operation
Remove the battery from the device
before undertaking any work on the
device.
This safety measure prevents acci-
dental starting of the power tool.
Start-up
 Charge battery
 Insert battery
-WARNING-
Use only original KRESS batteries with the volt-
age given on the type plate of your machine.
Use of any other batteries may lead to the risk of
injury or fire.
Use only the battery chargers and batteries listed
in the illustrated instructions.
Only these battery chargers and batteries are tai-
lored specifically to your power tool.
Additional functions
Sliding clutch
Always assume a safe standing position and hold
the power tool securely in both hands.
If the drill becomes wedged unexpectedly, the
power tool will suddenly jerk.
If the tool insert becomes caught or is
jammed, the drive to the drill spindle
is interrupted.
Remove the load from the machine
immediately by retracting the drill bit
Switch off the power tool and loosen
the drilling tool if the power tool has
jammed.
If the machine is switched on while
the drilling tool is jammed, high reac-
tion moments can occur.
ASL Auto-Spindle Lock (Option)
If the On/Off switch VI is not pressed,
the drill spindle and thus the tool
holding fixture are locked.
This enables screws to be driven in even when the
battery is flat and allows you to use the power tool
as a screwdriver.
English 23
EN
AkkuBS_CN-EN / 1004