Federal Emission Component Defect Warranty - Makita HTR5600 Manual De Instrucciones

For handheld engine : The Emissions Compliance Period referred to on the Emissions
Compliance label indicates the number of operating hours for which the engine has been
shown to meet Federal emission requirements.
Category C=50 hours, B=125 hours, and A=300 hours.

FEDERAL EMISSION COMPONENT DEFECT WARRANTY

EMISSION COMPONENT DEFECT WARRANTY COVERAGE - This emission warranty is
applicable in all States, except the State of California
Makita U.S.A., Inc., La Mirada, California, (herein "MAKITA") warrant to the initial retail
purchaser and each subsequent owner, that this utility equipment engine (herein "engine") was
designed, built, and equipped to conform at the time of initial sale to all applicable regulations
of the U.S. Environmental Protection Agency (EPA), and that the engine is free of defects
in materials and workmanship which would cause this engine to fail to conform with EPA
regulations during its warranty period.
For the components listed under PARTS COVERED, Makita Factory Service Center or service
center authorized by MAKITA will, at no cost to you, make the necessary diagnosis, repair, or
replacement necessary to ensure that the engine complies with applicable U.S. EPA regulations.
EMISSION COMPONENT DEFECT WARRANTY PERIOD
The warranty period for this engine begins on the date of sale to the initial purchaser and
continues for a period of 2 years.
PARTS COVERED
Listed below are the parts covered by the Emission Component Defect Warranty. Some of
the parts listed below may require scheduled maintenance and are warranted up to the first
scheduled replacement point for that part.
1) Fuel Metering System
(i) Carburetor and internal parts
(ii) Fuel filter, if applicable
(iii) Throttle stopper, if applicable
(iv) Choke System, if applicable
2) Air Induction System
(i) Air cleaner plate
(ii) Air cleaner case
(iii) Air cleaner element
EMISSON COMPLIANCE PERIOD
16