Ryobi ROBOYAGI Guía De Resolución De Problemas página 6

There is a yellow light on
LED indicator of the charging
station.
I have broken my boundary
wire. There is a blue light
on LED indicator of the
charging station.
I need to create a new
obstacle.
I need to change
boundary wire setup.
The blades are not turning
freely.
The ROBOYAGI is noisier
than when first installed.
Unable to log in to app
I can't connect ROBOYAGI
to my home Wi-Fi.
App shows that ROBOYAGI
is disconnected.
Roboyagi is docked but
battery is not charging.
4
English
Original Instructions
Internal loop error
Boundary wire setup
Boundary wire setup
my
Dirty or damaged blades
Blades / motors
App setup
Wi-Fi settings
Communication
between ROBOYAGI and the
app
Battery temperature
exceeded 45 °C.
Turn the mains power to the charging station off and on.
If issue persists, contact an authorised RYOBI service
centre.
Refer to the "Splicing the boundary wires" section of the
manual.
1. Turn off power to the charging station.
2. Locate the broken wire.
3. Join the wires together using supplied or purchased
couplers.
4. Turn on power to the charging station and ensure LED
indicator on charging station is green.
Refer to the "Splicing the boundary wires" section of the
manual.
1. Turn off power to the charging station.
2. Cut the wire nearest to your intended new obstacle.
3. Layout new wire around the new obstacle, making sure
to maintain the advised distances between wires and
obstacle.
4. Join the wires together using supplied or purchased
couplers.
5. Turn on power to the charging station and ensure LED
indicator on charging station is green.
Clean the blades frequently, following the guide in the
manual.
If you notice the blades are worn or damaged, please
replace.
Check and clean the blades. If you notice the blades are
worn or damaged, replace them.
Check and clean the wheel and around the wheel axles
if necessary.
Make sure that the blade disc is flat.
Ensure that you have completed the registration process,
and have verified your account via email.
If you have not received the verification email, please
check your junk/spam folder. If the email is still not
received, contact RYOBI through the website or an
authorised RYOBI service centre.
Ensure that a Wi-Fi Network is available in the work area.
ROBOYAGI works on a 2.4 GHz frequency.
Refer to the Wi-Fi Setup procedure in the manual.
If AUTO method does not work, please review your
settings and password, or try the Manual method of
connection.
issue Ensure that the mower is on and displays a Wi-Fi signal
on the screen dashboard.
Select Start before following instructions to close the
control panel cover.
Ensure that the most current version of the ROBOYAGI
app is installed.
If issue persists, contact RYOBI through the website or an
authorised RYOBI service centre.
has Allow the battery to cool down. The battery automatically
starts charging again when the temperature has reduced.