Tightening Torques; Troubleshooting; Storage; Preparing The Pump For Storage - Atlas Copco DIP 25 Instrucciones De Seguridad Y De Funcionamiento

DIP 25, 35, 65

Tightening torques

Screw, 8 Nm
A.
B. Screw, 20 Nm
Intake filter plug, 50 Nm
C.
Screw, 8 Nm
D.
E. Screw, 20 Nm

Troubleshooting

Fault Possible cause
The pump stops The impeller is
pumping or works clogged.
with reduced output.
The vanes in the air
motor are worn or
swollen.
The filter at the air
inlet is clogged.
There is water in The mechanical
the exhaust air. seal is not sealing.
© 2010 Atlas Copco Construction Tools AB | No. 9800 0958 90 | 2010-04-16
Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Action
Clean the impeller.
Send the pump to a
workshop, to have
the vanes polished
or changed.
Clean the inlet filter.
Send the pump to a
workshop, to have
the mechanical seal
changed.
Safety and operating instructions

Storage

Preparing the pump for
storage
After use it is important to flush out the pump using
●
a clean, neutral liquid. This is particularly important
if it has been used to pump acid, saline liquids or
other severely polluted or aggressive liquids.
When the pump is to be stored for 24 hours or
●
more, the air motor should be lubricated to protect
it from corrosion.
● Pour approximately 1 dl of anti-corrosion oil
directly into the air intake of the pump. Connect
the pump to the compressed air line, and run it for
a couple of seconds. It should be run at a very low
speed, in order to distribute the anti-corrosion oil
inside the air motor.
● After lubricating with an anti-corrosion oil, the air
intake must be plugged.
When a pump that has been in storage is to be
●
put back to use, pour a little oil directly into the air
intake before starting the pump.

Disposal

A used machine must be treated and disposed of in
such a way that the greatest possible portion of the
material can be recycled and any negative influence
on the environment is kept as low as possible, and
in respect to local restrictions.
13