Care And Maintenance - Bosch SHE45C Manual De Uso Y Cuidado

CARE AND MAINTENANCE

Maintenance Tasks
Certain areas of your dishwasher require occasional mainte-
nance. The maintenance tasks are easy to do and will ensure
continued superior performance from your dishwasher. These
tasks are:
Wiping up Spills and Splash-out
Water may occasionally splash out of your dishwasher, especially
if you interrupt a cycle or open the dishwasher door during a
cycle. To avoid loor damage and possible mold growth, do not
allow wet areas to remain around or under the dishwasher.
Clean the Stainless Steel Inner door and Tub
Clean the outer edges of the inside door panel regularly to
remove debris that might collect there from normal loading. If
spots begin to appear on the stainless steel tub or inner door,
make sure the rinse agent reservoir is full.
Check/Clean the Spray Arm Nozzles
Occasionally check the spray arms to ensure that the spray arm
nozzles (holes) are unobstructed. You must remove the spray
arms to check them for obstruction.
To remove the top spray arm:
1. Remove the empty top rack from the dishwasher.
2. Turn the rack upside-down. The top spray arm is held in
position by a locking nut as shown in Figure 30. Turn the
locking nut counter-clockwise 1/8 turn and remove it, as
shown in Figure 31 to release the spray arm.
3. Remove the spray arm as shown in Figure 32.
FIGURE 31
4. Look for obstruction in the spray nozzles.
5. If the spray nozzles need cleaning, lush them under run-
ning water.
14
All manuals and user guides at all-guides.com
FIGURE 30
FIGURE 32
To reinstall the top spray arm:
1. Return the top spray arm to its installed position.
2. Return the locking nut to its installed position and turn it
1/8 turn clockwise.
3. Return the top rack to the top rack roller guides.
To remove the bottom spray arm:
1. Remove the empty bottom rack from the dishwasher tub.
2. Grasp and lift the bottom spray arm as shown in Figure 33.
3. Look for obstruction in the spray nozzles.
4. If the spray nozzles need cleaning, lush them under
running water.
To reinstall the bottom spray arm:
1. Return the bottom spray arm to its installed position and
press it so that it snaps into place.
2. Return the bottom rack to its installed position
FIGURE 33
Check/Clean the Filter System
This dishwasher has a ilter system that consists of a Large Object
Trap/Cylinder Filter assembly and a Fine Filter. Select models
have an additional Micro Filter. The ilter system is located on
the inside of your dishwasher under the lower rack and is easily
accessible. During normal use, the ilter system is self-cleaning.
You should occasionally inspect it for foreign objects and clean
it when necessary.
CAUTION
To avoid injury, do not reach into the large object trap with
your ingers.The large object trap could contain sharp objects.