Instructions For Use; Preliminary Checking Operations - APRILIA MX 125 Manual De Instrucciones

INSTRUCTIONS FOR USE

WARNING
Before departure, always carry out a
preliminary checking of the vehicle to
make sure that it functions correctly
and safely, see the following table
( P R E L I M I N A R Y
OPERATIONS). The non-performance of
these checking operations can cause
severe personal injuries or damages to
the vehicle.
Do not hesitate to consult your aprilia
O f f i c i a l D e a l e r i n c a s e t h e r e i s
something you do not understand
about the functioning of some controls
or in case you suspect or discover
some irregularities.
It does not take long to carry out a
check-up and this operation ensures
you much more safety.

PRELIMINARY CHECKING OPERATIONS

Component
Front and rear disc
brakes
Accelerator
C H E C K I N G
2 stroke oil/
transmission oil
Wheel/tyres
Brake levers
Clutch
Steering
Side stand and center
stand
Fastening elements
Drive chain
Fuel tank
Coolant
Lights, warning lights,
horn and electric
devices
Check
Check the functioning, the idle stroke of the control levers,
the fluid level and make sure there are no leaks. Check
the wear of the pads. If necessary, top up the fluid tank.
Make sure that it works smoothly and that it is possible to
open and close it completely, in all steering positions.
If necessary, adjust and/or lubricate it.
Check and/or top up if necessary.
Check the tyre surface, the inflation pressure, wear and
tear and any damage.
Make sure that they work smoothly. If necessary, lubricate
the articulations and adjust the stroke.
The idle stroke at the end of the clutch lever must be
about 10 mm; the clutch must operate without jerking
and/or slipping.
Make sure that the steering rotates smoothly, without any
clearance or slackening.
Make sure that it works smoothly and that the spring ten-
sion brings it back to its normal position. If necessary,
lubricate joints and hinges.
Make sure that the fastening elements are not loose.
If necessary, adjust or tighten them.
Check the slack.
Check the fuel level and top up, if necessary. Make sure
there are no leaks or air bubbles in the circuit.
Check level
Check the proper functioning of the acoustic and visual
devices. Change the bulbs or intervene in case of failure.
Page
38-39-
40-70
71
3 6 - 3 7 -
60-61
43
39-40
42
ƒ
77
ƒ
66-67
36-82
44-45
78...81
use and maintenance MX 125
47