Hydrofarm Phantom CMH PHMH601013 Instrucciones página 7

Find a suitable location for the system with sufficient cooling and distance from any heat source.
Securely install J-hooks or other appropriate means of hanging support to your grow room ceiling,
grow tent overhead support rods, or greenhouse truss.
NOTE: If installing into drywall or plaster, use wall anchors and hooks rated to hold at least 50 lbs each.
The system can be hung two different ways: VERTICALLY, using the included eye hooks; or
HORIZONTALLY, using the included wire hanger hardware.
• To hang VERTICALLY, screw the eye hooks fully into the threaded holes in the center channel
of the top of the ballast (fig. 1).
VERTICALLY:
For overhead hanging
Using the center channel
and eye-hooks
• To hang HORIZONTALLY, insert the ends of the wire hanger into the two holes built into the
side of the ballast and also use the integrated hanger (hole) on the reflector armature between
the two reflectors (fig. 2).
VERTICALEMENT :
Pour une suspension
HORIZONTALLY:
supérieure,
utiliser le canal
For low profile locations
central et les œillets.
Using the wire hanger
and integrated hanger
on the reflector
armature
Using Hydrofarm item LULIFT or other reliable hanging method, suspend the system from your
VERTICALMENTE:
HORIZONTALEMENT :
overhead support.
Para colgarlo del techo
Pour des lieux à profil bas
mediante ganchos sujetos
utiliser le câble de suspension
POWER UP THE SYSTEM
al canal central.
et le crochet intégré sur
l'armature du
1. Plug the power cord into the power input on the main panel of the ballast.
réflecteur.
2. Plug the power cord into your power source (electrical outlet, 120/240V only).
HANGING THE SYSTEM
,
1
1
2
2
1
7
1
1
2