Bosch TR 200 Manual Del Usuario página 20

The present day is set by depressing the but-
tons "–" (o) or "+" (p).
If afterwards you wish to set the time, depress
the button (q).
When no more alterations are necessary
close the lid.
6.2.4 Control knob set to
"Heating"
Setting the heating programme
The time switch makes it possible to automat-
ically switch on the heating system up to three
times a day at a pre-determined time and to
automatically switch it off three times a day a
pre-determined time.
Those times can be determined individually
for each day.
It is also possible to set the same times for
each day.
To make programming more effective it is
useful to fill in the heating times into the table
provided (see chapter 10). The heating pro-
gramme which is used for most days of the
week (also applicable if the times deviate
slightly) should be filled in for all days in the
first step. The deviating times can later be ef-
fortlessly altered.
Turn the control knob (n) to
shows:
Select day +/-
Depress the button "–" (o) or "+" (p). All days
(or the present day) is displayed in the upper
line.
In the setting
All days
and "economic operation" will start at the re-
spective times each day.
If only one day of the week (e.g. Thursday)
was selected, the set programme for this day
always starts at the pre-set time on this day,
i.e. each Thursday both "heating operation"
and "economic operation" will start at the set
times.
One single day can be set by depressing the
buttons "–" (o) or "+" (p).
Between and
Sunday
played.
20
. The display (e)
both "heating operation"
is dis-
Monday All days
The heating times can be set for the displayed
day/all days. For this, depress the button
(q).
The display (e) shows:
1. Start heating
6:00
The required first starting time for heating is
set by depressing the button "–" (o) or "+" (p).
Briefly depressing the button alters the start-
ing time by 10 minutes, when the button is de-
pressed for a longer period the time runs fast-
er forward or backward.
When the required starting time is selected
depress the button
Now the respective first starting time for eco-
nomic operation must be set.
The display (e) shows:
1. Start econom.
22:00
The required first starting time for economic
operation is set by depressing the button
"–" (o) or "+" (p).
Briefly depressing the button alters the start-
ing time for economic operation by 10 min-
utes, when the button is depressed for a long-
er period the time runs faster forward or back-
ward.
As soon as the required starting time for eco-
nomic operation is selected depress the but-
ton (q).
The display (e) shows:
2. Start heating
--:--
Note: means that this starting time was
--:--
not programmed, i.e. only one start-
ing time for heating operation and
one for economic operation is pro-
grammed at initial operation (factory
pre-setting) or after a longer power
failure.
If required, the second starting time for heat-
ing operation can now be set as described
above, in the chapter "setting the first starting
time".
TR 200
(q).