Cosatto NITTY GRITTY Manual Del Usuario página 5

13 - fitting the soft goods
To fit the footmuff to the front seat, open the bumper bar (a), see step 14. Unfasten the harness,
slide the chest pads off the straps (b) and pass the harness straps through the slots in the footmuff
(c, d & e). Attach the fastener straps at the top of the footmuff to the back of the seat (f).
Refit the chest pads onto the shoulder straps and re-fasten the buckle.
To fit the babynest and headhugger to the rear seat, unfasten the harness and slide the chest pads
off the straps (g).
Unzip the front of the babynest (h).
Pass the harness shoulder straps through the slots in the babynest and headhugger (i). Pass the
waist and crotch straps through the slots in the babynest (j & k).
Refit the chest pads onto the shoulder straps and re-fasten the buckle.
14 - unlocking and locking the bumper bar
The front bumper bar can be opened for ease of placing and removing your infant from the
pushchair. To open the bumper bar turn the lever to the right as indicated by the arrow (a). Whilst
holding the lever in this position pull on the bumper bar to free it (b).
To close the bumper bar, push the end of the bumper bar to the slot until it click into place (c).
The bumper bar cover can be removed by unfastening the zip on the cover.
15 - rear seat footrest
The rear seat of your pushchair comes with a fold-away footrest which can be attached via strips
of fastener and press studs (a) to the back of the front seat.
As your infant grows and requires more leg room the footrest can be detached (b) and folded back
under the rear seat where it attaches to fastener strips.
16 - attaching and detaching the basket
The basket can be detached from the chassis. To remove the basket, unfasten the straps (a & b) by
releasing the press studs.
To refit the basket reverse the instructions above.
17 - attaching the rain cover
Your pushchair comes complete with a simple and quick attaching raincover. To attach the cover
simply slide the slot located in the top of the cover over the pushchair handles (a). Secure the sides
of the raincover using the fastener straps (b & c).
18 - folding the pushchair
If folding the pushchair with the hoods attached ensure the hoods are folded back (a & b).
To fold your pushchair, ensure the rear seat back is in the upright position. Pull the rear handle (c)
upwards till the pushchair begins to slightly fold - DO NOT FORCE IT.
Whilst pulling up on the release catches (d) push the handles away from you folding the
pushchair.
Secure the pushchair with the folding lock (e).