Bosch GWS18V-45 Instrucciones De Funcionamiento página 11

2610041372 09-15 GWS18V-45.qxp_GWS 9/18/15 10:00 AM Page 11
DISC GRINDING WHEEL ASSEMBLY
Disconnect battery pack from tool. Be sure
that wheel guard is in place for grinding. Place
BACKING FLANGE and GRINDING WHEEL
on the spindle. Thread on the lock nut and
tighten nut using the supplied lock nut wrench,
while holding the spindle lock in (Fig. 3).
TO REMOVE: Reverse procedure.
Not recommended for use with spin-on
wheels.
TYPE 27
GRINDING
WHEEL
ABRASIVE TYPE 41/1A AND 27A
WHEEL ASSEMBLY
Using the optional Type 41/1A wheel guard,
it is possible to perform limited cutting on
small stock such as metal tubes, piping or
rebar.
Do not attempt to cut large stock or sheets of
metal as this tool is not designed to be a
dedicated cutting tool.
Always use Type 41/1A
protection guard for cutting.
Disconnect battery pack from tool. Be sure
that wheel guard is in place for cutting.
When using mounting wheels, thread
BACKING FLANGE onto spindle, then place
WHEEL on the spindle. Thread on the lock
nut and tighten ut using a lock nut wrench
provided with adapter kit, while holding the
spindle lock in (Fig. 4).
TO REMOVE: Reverse procedure.
TYPE 41/1A ABRASIVE
STRAIGHT GRINDING WHEELS
Do not use Type 41/1A
abrasive wheels designed
WARNING
for straight/die grinding. This tool is not
designed for use with Type 41/1A abrasive
straight/die grinding wheels.
FIG. 3
SPINDLE
SPINDLE
BACKING
FLANGE
LOCK NUT
FIG. 4
TYPE 41/1A
CUTTING WHEEL
-11-
TYPE 27
WHEEL GUARD
BACKING
FLANGE
TYPE 27
GRINDING
WHEEL
LOCK NUT
SPINDLE
TYPE 41/1A
WHEEL GUARD
BACKING
FLANGE
LOCK NUT
TYPE 27A
CUTOFF
WHEEL