HoMedics UHE-WMTF185 Manual Del Usuario página 5

normally for 30 minutes prior to testing. Testing was conducted by an independent third-party laboratory.
PROGRAMMABLE DIGITAL HUMIDISTAT
The default humidistat setting is CO (continuous on). The programmable humidistat can be set in 5%
increments, from 35% to 55% humidity.
To program the humidity level, press the programmable humidistat
increase by 5% each time the button is pressed and will be displayed on screen. Press the humidistat
button repeatedly until the desired setting is reached. The display will show the set humidity level.
NOTE: To eliminate any programmed humidistat setting, continue to press the programmable humidistat
button until you reach CO (continuous on), one level above 55%.
NOTE: When the set humidity level is reached, the humidifier will cycle off until the humidity in the room
drops 7% below the set humidity level. The unit will cycle on until the set humidity level is reached again.
NIGHT-LIGHT/DISPLAY LIGHT
Press the night-light/display light button once to turn on the night-light. The light at the bottom of the
water tank will turn on, illuminating the tank. Press the night-light/display light
to leave the night-light on, but turn off the display light. Press the night-light/display light
third time to turn off the night-light and display light so no lights are illuminated. Press the night-light/
display light button a fourth time to turn the display light back on.
PROGRAMMABLE AUTO-OFF TIMER
Press the programmable timer button until the desired timer setting is lit on the display. The
programmable timer will cycle through the following settings:
0 hours, 2 hours, 4 hours, 8 hours. To cancel the timer at any time, press the programmable timer
button until 0 hours is shown on the display.
NOTE: Always be sure the humidifier has a full tank of water prior to using the timer setting.
AUTO-OFF
When the water in the tank is empty, the humidifier will turn off and the out of water
illuminate red on the display indicating it is time to refill the water tank.
NOTE: It is normal to have a small amount of water in the water reservoir during and after use.
CLEAN TRANSDUCER/ULTRASONIC MEMBRANE
The clean transducer/ultrasonic membrane indicator will illuminate after 60 hours of use, indicating it is
time to clean the transducer/ultrasonic membrane. See cleaning instructions in the Cleaning and Care
section of this manual. After cleaning, press and hold the clean transducer reset
to reset the indicator.
button. The humidity level will
button a second time
button a
indicator will
button for 3 seconds
8
HOW TO USE
ESSENTIAL OIL
Use your favorite essential oil to deliver aroma into the air.
NOTE: For use with the included HoMedics essential oil pads only.
NOTE: Do not leave a filled essential oil pad in the oil tray of the humidifier if it will be out of use for a
long period of time.
ARE ESSENTIAL OILS SAFE TO USE AROUND PETS?
We should always exercise caution when using essential oils around our pets. Keep all essential oil and
aromatherapy products (like diffusers) out of reach of pets. Keep open bottles away from pets to avoid
internal consumption. We do not recommend the topical use of essential oils on pets, as they have a
strong sense of smell and cannot get rid of the oil if they don't like it or it is disturbing them. When
diffusing essential oils around pets, always diffuse in a well-ventilated area and leave an option for them
to remove themselves from the space, such as leaving a door open. Every animal is different, so carefully
observe how each animal responds when introducing an essential oil for the first time. If irritation occurs,
discontinue the use of the essential oil. We recommend seeking medical attention if ingestion of essential
oil occurs.
ADDING ESSENTIAL OILS
WARNING: PUTTING OIL ANYWHERE BUT THE OIL TRAY WILL DAMAGE THE HUMIDIFIER.
1. The oil tray is located on 2. Push to open and remove the tray. Place 1 essential oil
the back of the humidifier. pad (3 included) into the oil tray.
9