Technical Specifications - miniland baby digimonitor 3.5 touch Manual Del Usuario

ENGLISH
Problem
You cannot charge
the battery in the
parent unit
If the Baby Unit has
lost its link with the
Parent Unit
6. MAINTENANCE
· Clean the surfaces of the camera and monitor with a soft, lint-free cloth.
· If the units become dirty, use a lightly dampened cloth to wipe surfaces, taking care to not allow
water into any openings.
· Never use cleaning agents or solvents.

7. TECHNICAL SPECIFICATIONS

Frequency
Operating Range
Nº of configurable channels
Nº of automatic channels
Power (parent unit)
Rechargeable battery for monitor
Power (baby unit)
Operating time with battery fully
charged (parent unit)
Jack to RCA compatible adaptor cable format
MiniUSB-USB compatible cable
8. INFORMATION ON THE DISPOSAL OF BATTERIES AND PRODUCT
· Remember to remove the batteries and dispose of them in a responsible manner when
disposing of the baby monitor.
· You should not mix products bearing the crossed-out rubbish bin symbol with your
domestic rubbish.
· These products should be taken to the collection points allocated by the local
authorities for appropriate treatment.
Alternatively you may contact the point of sale where you purchased the product.
Hereby, Miniland S.A. declares that this 89175 digimonitor 3.5" touch is in
compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC.
Possible Cause
The AC/DC adapter is not
plugged in
A non-rechargeable battery
has been used
The camera and monitor may
be too far apart
The link between both units
has been lost momentarily
The link between both units
has been lost
Solution
Plug in the adapter
Only rechargeable batteries can be
used (3.7 V, 1200 mAh Li-ion battery):
check the battery and if necessary
replace it with the one supplied with
the appliance
Move the monitor closer to the
camera
Reset the units by disconnecting
them from the electrical power.
Wait about 15 seconds before
reconnecting. Allow up to one minute
for the Baby Unit and the Parent Unit
to synchronize.
Pair the camera and monitor again.
See 5.2.6.8.1.
2,4 GHz DIGITAL (FHSS)
Up to 230m (straight line and open space)
4
24
Input: 100-240 VAC 50/60Hz 300mA
Output: 5V DC 800mA
1 x 3.7 V, 1200 mAh rechargeable Li-ion
Input: 100-240 VAC 50/60Hz 300mA
Output: 5V DC 800mA
Continuous use 5 hours
Figure D
USB cable for data transfer
42