Technical Specifications - miniland baby digital camera 1.8 Manual De Instrucciones

ENGLISH
Problem
The camera does not
transmit
You cannot hear the
baby on the parent unit
Interference or poor
reception
If the Baby Unit has
lost its link with the
Parent Unit

8. TECHNICAL SPECIFICATIONS

Frequency
Operating Range
Nº of configurable channels
Power (parent unit)
9. PRODUCT DISPOSAL INFORMATION
· Remember to dispose of the product responsibly.
· Do not mix products bearing the crossed -out bin symbol with your general
household waste.
· For the correct collection and treatment of these products take them to the
collection points designated by your local authority.
Alternatively contact the retailer who sold you the product.
Hereby, Miniland S.A. declares that this 89179 digital camera 1.8" is in compliance with
the essential requirements and other relevant provisions of Directive 1999/5/EC.
Possible Cause
The camera is not turned on
Camera: the power adapter is
not plugged in
VOX mode or Standby mode
are active
The volume setting of the
parent unit is too low
Other electronic devices may
be interfering with the signal
The camera and monitor may
be too far apart
The battery power may be too
low
The camera or monitor may
be placed too close to many
metal objects
The camera and monitor may
be too far apart
The link between both units
has been lost momentarily
The link between bothunits
has been lost
Solution
Press and hold down button (III) for
2 seconds
Plug in the power adapter
To see
continuously, disconnect the VOX or
Standby mode on the Monitor
Set the volumen to the highest level
Move them away from the device
Move the monitor closer to the
camera
Plug in the power adapter
Move them away from the device
Move the monitor closer to the
camera
Reset the units by disconnecting
them from the electrical power.
Wait about
reconnecting. Allow up to one minute
for the Baby Unit and the Parent Unit
to synchronize.
Pair the camera and monitor again.
See 5.2.6.
2.4GHz FHSS
250m (straight line and open space)
4
Input: 100-240VAC 50/60Hz Output: 5V
800mA
16
the monitored
15 seconds before
area