Important; Choosing A Suitable Location - miniland baby digimonitor 3.5 touch Manual Del Usuario

ENGLISH
operating properly or has suffered any damage, contact the authorized Miniland service center to
request inspection and repair of the appliance in order to avoid any possible risk.
8. DO NOT attempt to repair or adjust any of the electrical or mechanical functions of the unit
since, if you do, the guarantee will be made void.
9. Check the voltage of your home in order to ensure that it matches the voltage indicated in the
specifications of the appliance.
10. If you are not going to use the baby monitor for a long period of time, always unplug the
power adapter. To disconnect the appliance from the mains, hold the transformer and remove
the plug from the socket. Never pull on the cord itself.
11. This product is designed for indoor use only. The unit should not be exposed to rain, moisture,
dripping or splashing. No objects filled with liquid should be placed on top of, or beside the
product, such as a glass or vase. This item should not be used near water.
CAUTION
· This baby monitor is designed to give parents peace of mind when they are unable to be in the
same room as their baby. This product is not a substitute for supervision by adults. It is necessary
for one parent to stay near the monitor when in use. The baby monitor is not a medical device
and you should not entrust the welfare of your baby to it. It is important that you regularly visit the
baby's room in person to ensure that everything is in order.
· Never use this baby monitor in cases in which the life or health of the baby or other people,
or the integrity of a building, depend on its operation. The manufacturer accepts no liability or
claim for death, personal injury or property damage resulting from the malfunction or misuse of
the product.
· Misuse of this Wireless Baby Monitor could result in legal action.
· Use this product responsibly.
IMPORTANT: Please note that any change or modification to the equipment not performed
by the Miniland technical service will not be covered by the product guarantee.
3.2. TIPS FOR RADIO INTERFERENCE
This equipment has been tested and meets the requirements of Directive R&TTE 1999/5/EC.
These requirements are designed to offer reasonable protection against harmful interference
in a residential installation. If the unit is not installed and used according to the instructions,
it could cause harmful interferences to radio communications. Note, however, that there is no
guarantee that interference will not occur in a particular installation. If the baby monitor causes
interference to the radio or television, which can be determined by switching it on and off, you
are recommended to try and correct the interference as follows:
· Reorient or change the position of the receiver.
· Increase the distance between the equipment in question and the baby monitor.
· Connect the equipment to a different socket from the one used for the receiver.
· Check with the Customer Service Department.
To ensure compliance with Directive R&TTE 1999/5/EC, this equipment has special shielded
cables. Operation with non-approved equipment or with unshielded cables will probably cause
interference to radio and television reception.

3.3. CHOOSING A SUITABLE LOCATION

· Place the electronic device out of the reach of children in order to avoid accidents.
· The baby unit should be placed at a distance of at least 1 to 1.5 meters from the baby's cot.
Never place the baby unit inside the cot, bed or playpen, or attach the tripod to them. Make sure
the unit, cables and adapter are out of reach of the baby and other young children.
· Place the baby monitor in a place where the air can circulate freely. Do not place on soft quilts
or blankets, or in the corners of cupboards, shelves, etc.
· Place the baby monitor away from heat sources such as radiators, chimneys, cookers and
direct sunlight.
· Place the camera away from TV sets, repeaters and radios. The intense radio signals generated
by these elements could cause noise or even sounds and images to appear on the monitor. If this
occurs, move the camera to another location.
31