Maxon C2 Instrucciones página 8

1. Measure the service body (FIG. 8-1).
• Overall body width
• Width of body opening:
Model C2-54 requires 48"-50" opening.
Model C2-60SB requires 54" opening.
• Maximum bed height (truck unloaded)
2. Compare measurements with the dimen-
sions for your Liftgate shown on Sheets 5
and 6.
3. Remove Liftgate installation kit shipped
with Liftgate. Then verify the correct parts,
shown on Sheets 1 and 2, were shipped
with Liftgate.
`
!
Liftgate will not stand upright without
the shipping angles. Before removing
the angles, make sure Liftgate is sup-
ported with forklift or pallet jack. Injury
& property damage could result if Lift-
gate falls over.
4. Support Liftgate on shipping pallet with
forklift or pallet jack. Then, unbolt shipping
angle from each column on the Liftgate
(FIG. 8-2). Save shipping angles to use for
lower mounting brackets.
LIFT CORPORATION Sht. 8 of 55 DSG#
PREPARING LIFTGATE
CAUTION
M-15-02
OVERALL
BODY WIDTH
BODY
OPENING
MAX. BED
HEIGHT
FIG. 8-1
3/8"-16 BOLT,
3/8" LOCK WASHER,
3/8"-16 NUT
(4 PLACES)
SPACER
(2 PLACES)
LH COLUMN
RH COLUMN
REMOVING SHIPPING ANGLES BOLTED
TO COLUMNS OF C2 LIFTGATE
FIG. 8-2
Rev. E Date: 09/13/21
ANGLE
(2 PLACES)